New winch switch set up

Mine didn't drop at all, but I reduced weight with synthetic rope, plus the springs are new.

Mine didn't drop much, but it was already pretty low in the front. I think I have some stock spring droop. I think I am going to be amazed at how much lift the 2Inches will actually be once I get it on. I think mine sits lower than stock to start with.
 
...I think I am going to be amazed at how much lift the 2Inches will actually be once I get it on...

I bet you will be. With my new springs it only dropped about 1/4" after adding the aftermarket bumper and winch.
 
Measure the front springs from bottom coil to top, not including the spring pad cushion at the top. 12" is stock height.
 
Measure the front springs from bottom coil to top, not including the spring pad cushion at the top. 12" is stock height.

I haven't ordered my lift yet. I am going to this week, but was waiting for some gift cards and rebates. This Jeep is costing me some dough.
 
I
I haven't ordered my lift yet. I am going to this week, but was waiting for some gift cards and rebates. This Jeep is costing me some dough.
I hope you're not waiting on us to send you gift cards. As much as I'd like to see you get that lift on there....I have some things I need to get too.
 
  • Like
Reactions: ac_
I haven't ordered my lift yet. I am going to this week, but was waiting for some gift cards and rebates. This Jeep is costing me some dough.

I was just curious to see if and how much your stock springs were sagging. An OEM spring in good condition should measure 12".