Artsifrtsi
I just wanna go wheeling... From Huntsville, AL
Latest activity Postings Images About
-
-
Or, just turn it back slightly until the noise stops. -
Artsifrtsi replied to the thread Genright or Motobilt highline fenders?.There are also these... but not aluminum https://undercoverfab.com/tube-fenders-/104-ucf-highline-front-tube-fenders-for-jeep-tjl.html
-
Artsifrtsi replied to the thread How to tell if your inner C's are bent.I’d say the one marked good is bent too…
-
Artsifrtsi reacted to freedom_in_4low's post in the thread Aftermarket can't even get interior door handles right with
Like.
Even if your back tires aren't doing it, the wind whipping around the side of your windshield will. When I ran doorless on my 99 with... -
Artsifrtsi replied to the thread Aftermarket can't even get interior door handles right.Just run a drill bit to barely make an indent to hold the paint
-
Artsifrtsi replied to the thread Aftermarket can't even get interior door handles right.You could clean the lettering off, and paint a red/orange dot and greed dot to mark safe/fire…
-
Artsifrtsi replied to the thread Aftermarket can't even get interior door handles right.The anti tamper torx is too easily defeated with a drift punch. The doors for mine have lived in the garage since Easter weekend, I...
-
Artsifrtsi replied to the thread TJ build discussion.? Over stock, yet shorter? Regardless, as @jjvw states, there will be a lot of work to get 35 and up to work properly. Long enough...
-
Artsifrtsi replied to the thread Aftermarket can't even get interior door handles right.I just lived with the issue… hell, I never lock the doors…
-
The best way to fix this problem is get a 12V power supply, pull the unit out of the jeep and bench test it. Let it power up with just...
-
Artsifrtsi replied to the thread TJ build discussion.Not entirely accurate. Yes, without new control arms, the wheelbase will shorten as the stock arms swing towards each other. The...
-
While changing the spider gears would be easy process; you will need to THOROUGHLY clean (spray out) the inside of the housing, the gear...
-
Artsifrtsi reacted to Kraken72's post in the thread Bestop tab on rear corner keeps popping out with Like.
Well contacted bestop, sending me a new top minus windows.
-
Artsifrtsi replied to the thread Bestop tab on rear corner keeps popping out.I agree with the consensus that the stiffener is too far down, and pushing the tab out... does it look like that on both sides? Make...
-
Artsifrtsi reacted to JeepZilla380's post in the thread Bestop tab on rear corner keeps popping out with Like.
Not to pile on the stiffener group, but on my Bestop SuperTop NX I dont see the white plastic stiffener down as far as your picture...
-
-
Loading…
-
Loading…
-
Loading…