Recent content by bobsxlch

I'm in the process of doing a re-gear of my 97 TJ and also doing a 3" suspension lift. I purchased all Adjustable control arms, track bar and sway bar. Do I just simply adjust the over all length of each 3" longer than stock length, is it that simple?

Thanks for the photos.

Id like to buy a proven and trusted heavy duty clutch and Flywheel for an upcoming stroker build. There are a ridiculous amount of clutches and manufacturers claims that makes it very hard to decide on the best option....

Relay Buddy Super Pro Kit https://www.amazon.com/dp/B0BFBTW5B8/?tag=wranglerorg-20

I get that and do it but it's still not a quick visual check.

I have the same kit and clipped and led on the output, but the problem is, this isn't a permanent solution only good for home troubleshooting, I'm looking for easier solutions when I'm on the road

I actually thought about it and was just discussing it with the electrical tech at work. We have some cube relays that have transparent housing so you can see the coil pull in and some have led's to let you know they are functioning. Just looking for quick and easy way to troubleshoot an...

A few months ago I put a fuel pressure gauge on the fuel rail so I could tell at a glance the pump was working. Yesterday, the jeep wouldn't start but it cranked, I seen the pressure gauge was at zero, so I switched the horn rely for the fuel pumps and it started right up. I thought it would be...

Does anyone know if they make a relay that has an LED indicator to replace any of relays in the Power Distribution Box? I just feel it will be a quick visual aid in troubleshooting electrical problems.

It's just a bronze bushing, seems simple enough..... Thanks

Now that I'm aware of that I'll look into it. I have a line on a 4.0 engine that's cheap but was set up for an automatic transmission.

I was just saying I'm doing a complete rebuild and putting a new crank in, so I should be good.... Thanks for the feedback

I'm not sure that will matter since I'm doing a complete engine rebuild and putting a new crank in it.

Can you just remove a flex plate from a 4.0 engine and put a flywheel on it so I can bolt up a manual transmission to it?

I'm stuck on this voltage drop of 2 volts, it just doesn't make sense. I appreciate the advice but this isn't answering the question.