Recent content by Bstahl875

Yes! I am 100% good with that 😁

I put a piece of tape on the drive shaft and had my wife count as it went by. 4.5 times so 4.56 gears

2002 TJ. VIN number says 3.07 gears. Diff says 3.77. Installed the correct gear for the speedo (tire size and gears) and my speedo is still off. Is it possible someone put different gears in it and it still says 3.77….meaning they didn’t mark it somehow? Is pulling it apart and counting the...

Worked perfectly. Thank you!

I will give that a try tomorrow when I get back to it. I’ll let you know how it goes.

I will give that a try tomorrow when I get back to it. I’ll let you know how it goes.

2002 TJ 4” lift to 2” in rear. I pulled off the rear upper control arm (which appears to be OEM) and tried to install the new adjustable control arm. The control arm is adjusted all the way tight and it’s off by about 1/4 of a bolt hole. I feel like the axle needs to be moved back. I also feel...

I believe the original lift was a Rough Country based on feedback on this forum. I did a mix match to lower it. JKS springs, Rancho shocks, Teraflex sway bar links, core4x4 adjustable control arms.

I plan to replace all of the bolts anyway so I guess I’ll pull the spacers while I’m at it. No need to brush my teeth with two toothbrushes. 🤣

Honestly I’d like to avoid removing them. I’ll just get everything tightened up and see how she drives when I’m done with the lift. Thanks for the info.

2002 that had a 4” lift and I installed 2” in back and 2.75” up front. Last night while under the Jeep I noticed one of the bolts missing on the transfer case skid plate and another extremely loose. I will fix/replace those bolts. My question is really: the case appears lowered by about an...

Problem is I already bought the links. I just need the quick disconnects. I think I found some that will work.

Replacing the sway bar links on my 02. The bolts and quick disconnects seem meh. The driver side was ok, but the passenger side I think needs replaced. I cannot seem to find them. Help please! I did find these but they seem 🤷🏼‍♂️ BOKOP, FOR WRANGLER TJ JK JL SWAY BAR QUICK DISCONNECT PINS...

I’m going from a 4” lift to 2.75 “ in the front. I bought OEM upper and lower control arms to replace the old ones. The lower control arm does not have a cam bolt. Is it necessary? Any other advice is anything at all would be helpful.

2002 Wrangler. Going to 2.75” in front and 2” lift in rear. Going to need to replace the sway bar links on the current 4” lift. So many options…..I need some help. Likely to never go off-road. I’ve looked at several and they are a lot more than I want to spend, over $300 for the JKS quick...