Recent content by CDNTrooper

I just bought a new chain and installed it and it has significantly less slack than yours.

Here is a ph

I purchased these and re-wired the headlights and a significant difference. Rampage Headlight

I put the, on my stock height TJ and I like the.

A local auto wrecking specializes in Jeeps by me. I’m going there Saturday to look for a part. I will see, but to be clear you just need the wiper motor cover for the hardtop and nothing else?

I have a 97 TJ and just fin installing a double din stereo and backup camera. I didn’t go crazy and bought a ATOTO A6 Performance. Was easy to install aside from the previous owner cutting the original harness. I decided to mount mine in the center of my spare tire. I drilled a hole in the...

The attached pdf is a Sonnax guide to help with issues you may have. the 30RH is basically a A904. good luck

Well I thought i would share a bit more on my transmission rebuild. My Jeep has a 30RH and overall not to bad of a job. I strongly suggest if doing a rebuild to invest in the Sonnax problem solver parts as it makes a big difference. I bought the following for my rebuild. Transmission parts...

Thanks, my daughters really liked the oem colour so I stuck with it but a bit more work to paint.

Starting to get it back together but I’m being just too picky. I’m just wiring in a ATOTO Double DIN with carplay, gps, and OBDii

The ground that effects your dash lights is on the passenger side. If you remove the passenger side speaker cover, just below the speaker there is a ground wire. I unbolted it scuffed up th3 area and bolted it back down and resolved my issue.

Here is the windshield installed

No I dI’d the install on my own, I positioned two suction cups so hold on to it and aligned the side that was closest to me and it went in. You only need two tubes of Urethane and I agree it was bleep to pump that stuff out. One windshield manual no problem but more and I would by an electric...

I did my windshield today took all of an hour, not an issue and one of the easiest windshields to unstall. I had a clean frame to work with as I just repaired it and painted it. So here is what I did. I used scotch brute pad to scuff the surface. add two coats of primer. put back in the...

Well got the body and paint do, just starting to RE-assemble