Recent content by CJsWranglers

I picked up a DANA 44 axle that was totally striped down, that I am putting in my TJ. Well almost... it has in it new 5:13 gears with ARP air lockers. The axle tubes have been wiped clean of any brackets. I know I need to get lower control mounts and a truss for the upper control arms since I...

I don't have a rubicon

I am looking and on the search for a complete wire harness for the interior of my 2005 TJ. I am rebuilding my TJ and I bought a tub that was totally striped afteer I sold my rust bucket with only the wire harness left in it... I guess I should have done the work to remove it but hindsight is...

I am open to the idea of an automatic... which one are you running with

The motor came to me stripped down this is why I am looking for a transmission and transfer case knowing I cant use the stock ones

OK which transmission did you go with?

Thanks.... 4-speed... how well do the gears mesh together? I like the idea of a really low low first gear.

I was wondering what everyone is using for a transmission and a transfer case after doing a LS swap? I have a 2005 TJ with 6-speed manual(NSG370) stock and a stock transfer case(NV245). My intentions are for rock crawling NOT my daily driver. It will be trailered. I prefer a manual trany over...

Thank you for your input and I'll probably go with the NV4500 because I prefer standard

Thats what I am really looking for is info on a transmission because I am adding so much weight I am upgrading the motor and the trany to compensate... I prefer a manual because thats what I am used to but not objecting to automatic. I need a good reason not just what people prefer... Why do...

I have a 05 TJ with a 2.4 engine(I know problem one) Which in the past it has served me well(the engine that is) but since I have added a lot of weight. I have put on DANA 44 axles w/5.38 replacing the stock 30 & 35(added weight) I have added Clayton long arm stretch/lift with front and rear...

This is exactly what I was looking for. Thank you so much

I am in the process of rebuilding DANA 44 axles. I am looking for the check valve on the end of the axle vent tube. I cant seem to find it anywhere.... I was wondering if someone could lead me in the right direction on finding them

Stevemack Thanks for your response. Like you I am from the Northeast and its soo much different than the Southwest when it comes to wheeling. I see that Savvy is really popular on here along with a few other upgrade options. Which I am not knocking everyone has their preference. Anyhow I was...

I want to thank everyone for their input on my question on if I should stretch my TJ. I what I got from you guys is that it might be more work with little gain but it definitely can be done, which I wasn't sure about. I don't see the point of a Mid Arm Kit if you want to keep OEM. This is going...