Recent content by COYOTE83

Ok so let me start off by saying I’ve read every thread I could find (maybe I didn’t find the right one) and I’ve watched the rokmen video as well as a few others. Installing my motor mount spacer block lift and I’m going by the rokmen video. Followed all the steps and got to the part where...

Ok, I was delayed for a while due to personal reasons but now I’m finishing up the RGA front axle shaft install and I think the front passenger axle shaft isnt fully seated. I can get it to engage the splines and spin the drive shaft but when I compare it to the driver side, it seems like I...

Ok so I messed up. I was putting together my RGA front axle shafts and I forgot to put the damn snap rings on the u joint cross before I hammered it together. So I pressed the u joint apart so I could install the snap rings and I pressed one cap through the yoke and now I’m stuck with this...

Alright so I finally got all of my parts I’ve been waiting for and got the jeep in the shop for maintenance and upgrades. And I’m running into problems. Info: 2001 sport with rubicon axles, rubicon lockers. 4.10 Issues: I’m Installing revolution axle shafts in the rear and when I removed the...

I did not. Which is why I can’t complain too much I reckon. Still though, it was just ridiculous.. My concern is the missing pieces more than the paint damage. Since I didn’t order direct they probably won’t just ship me the few pieces I’m missing. I’ll probably have to deal with returns with...

I finally got my parts I’ve been waiting on today. Savvy 1.25 BL and transfer case cable shifter. 4qt redline mtl Front and rear antirocks. The boxes for both antirocks were beat to shit. Busted all to hell. Holes taped up, tape wrapped all around the boxes and shipping stickers all over it...

How big of an effect on performance and economy does deleting the cats have ?

Ok dumb question time… What are the reasons for changing the flasher? I’ve read a little about hyper flash before, and some annoying sounds, but are there any detriments or potential damage to the circuit when using a stock flasher with LED tail lights? Increased heat and wear on the relay...

you guys have got me second guessing plasti dipping my wheels. To be honest though, I was already second guessing doing it when I ordered the plasti dip a few months ago.

I finished brakes and bearings on all 4 corners on this one and got it back on the tires so I can drive her out tomorrow, then drive the jeep in so I can do some maintenance and a few upgrades on it.

I haven’t heard anything yet. I’m still waiting on a few other things also.

I like your setup. What rear roll bar bags are these and do you like them?

I haven’t hooked it up to a battery yet. The jeep came with a brand new badlands 12000 installed and this xd9000i was included. I think I’ll try to find some test procedures and try to verify what’s wrong with the warn. I don’t have the original remote. I think I’ve read that the harbor...

Ok well that’s not so bad. I’m just picturing them as unwieldy when rolled wrapped or coiled. Good to know that they’re easy to store. How did you make a 35’er?

How much space does a kinetic rope (20ft or 30ft) take up behind the seat of a tj? I think I could carry one back there, but I don’t know about two. Or are they more compact and easy to stow than I’m imagining?