Latest activity Postings Images About
-
-
dbbd1 replied to the thread Brakes are smoking and feel stuck.Yes, this I know. I was just wondering what else might be screwed up. -
dbbd1 replied to the thread Brakes are smoking and feel stuck.Just to make sure... The calipers were installed with the bleeder up on top, not pointing down?
-
dbbd1 replied to the thread It sounds like my Black Magic Brakes are dragging.Welded up, ground down flat (angle grinder and flapper), using a straight edge to check for square. And, from what I can tell, no pad...
-
dbbd1 replied to the thread It sounds like my Black Magic Brakes are dragging.Thanks. And the divots are fixed.
-
dbbd1 replied to the thread It sounds like my Black Magic Brakes are dragging.Thanks. Those are next on my list to look at. I just replaced the calipers (with new) new rotors, scuffed the BMB pads. My lines are...
-
dbbd1 replied to the thread Plastic restoration.Flood penetrol. In the paint department. It lasts about a year.
-
dbbd1 replied to the thread It sounds like my Black Magic Brakes are dragging.When lubricating the caliper slides, should you also put some lube into the rubber accordion boots?
-
dbbd1 replied to the thread It sounds like my Black Magic Brakes are dragging.Do you still have a part number laying around? Thanks
-
dbbd1 replied to the thread Parasitic battery draw unsolved / radio.Plug in the radio again and disconnect the gauge cluster. Check your parasitic draw again.
-
dbbd1 replied to the thread P1294 CEL code (for idle speed performance).Referring to your likely solution- you may want to start with a smoke test. Thiscwill help you check for leaks, cracked vacuum lines...
-
dbbd1 replied to the thread Water rolls off the lifted hard top glass into the Jeep.Run a bead of clear silicone along the top edge to deflect the rain.
-
dbbd1 replied to the thread Which type of bolt head?.Mine are zinc coated something. The lower the grade of the stainless, the more a magnet will attract to it. Maybe it’s cheap...
-
dbbd1 replied to the thread Which type of bolt head?.You most certainly are not. But you’re banking good karma.
-
dbbd1 replied to the thread Which type of bolt head?.Here you go…...
-
dbbd1 replied to the thread Which type of bolt head?.Yes, the bolts that were on there were 10mm on the upper hex and 12mm on the lower hex. Since these oddball ones are "supposed" to be...
-
-
Loading…
-
Loading…
-
Loading…