Recent content by djbrand1

1998 Jeep Wrangler SE with upgrades. 4.0 6 cylinder with manual transmission. Probably one of the lowest mileage 4.0's out there that's original? -Transmission - NV3550 out of a ~2003 wrangler (borg warner clutch) -231 Transfer case with Slip Yoke Eliminator -Front axle - dana 30 out of ~2003...

1998 Jeep TJ Sport Wrangler. 4.0 liter 6 cylinder with 5 speed manual transmission. Jeep is in good condition. Currently restoring the interior dash and door panels which have been coming out great. Great off roading upgrades. Front Locker, limited slip rear diff, disconnecting sway bars, full...

So started tracing the constant and ignition power on the back of C2 connector. At the connector I get continuity showing for the constant always and get continuity on the ignition power with ignition on. Ignition power wire is orange and tried tracing that but got lost into the large harness...

@woody367 I am currently having the same issue, but all my fuses currently look good. I have no power at the cluster C2 (Blue) connector at pins 9 and 8. So fuse 10 behind the glove box is good. All fuses in the block under the hood are good. What were the 3+ feeds you checked/found if you...

Hi, I'm troubleshooting this with the OP as well. Fuse 17 was at the fuse panel behind the glove box inside. No power, constant or when keyed to ignition. Fuse 17 in the box under the hood, fuse is good. Didn't test for constant/keyed power there yet. Underhood light has power, driver side...