Recent content by drpete1023

  1. D

    Where can I purchase a new Mopar camshaft position sensor?

    Update: the washer I installed as mentioned earlier is still installed and no CEL or rough idle or start at all since. FYI, I ordered a Genuine Chrysler sensor cable, came in yesterday in an OEM MOPAR box! Have not compared the one installed to this one as the Jeep is running fine and do not...
  2. D

    Where can I purchase a new Mopar camshaft position sensor?

    Update: I read somewhere where an individual said put a small washerspacer behind the sensor cable bolt and between where it attaches to the ODPA. I did that on Tuesday and have not had a starting/running issue since. Stay tuned. I also found on Amazon another sensor cable made by Genuine...
  3. D

    Where can I purchase a new Mopar camshaft position sensor?

    Did you pull out the ODPA and actually inspect the cam gears? Okay: -Jeep would not crank back in 2017 (put in a refurb PCM from dealer-never heard of wranglerfix at that time). That seemed to work for a while. (IF it were the PCM, why just one single code and not multiple codes if it were...
  4. D

    Where can I purchase a new Mopar camshaft position sensor?

    Give me a call when you get this (228-297-1371) Sent you a message, give a call.....
  5. D

    Where can I purchase a new Mopar camshaft position sensor?

    Started my Jeep today, hard to start, P0340 code. Cleared the code with my scan tool, starts right up and runs fine. I have the crown ODPA, never to keep the sensor cable off the old one. Just ordered the NGK for the heck of it. I do not think it is my computer, I know I have some wear on my...
  6. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    Well, check engine light and P0340 code has not returned since doing the new heat shield kit. My buddy with a 2005 TJ said he also replaced the factory 5 blade fan and a 93 or 94 explorer plastic 9 blade works in the same spot and bolts right up, new fan clutch and some say use a heavy duty one...
  7. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    Here is a photo of the completed job. The kit was not a perfect match as I had to use a pair or scissors to cut around brackets and such, then I used some zip ties to neaten things up. Remove the fuel line from the fuel rail like the instructions say first, and then you can drain and catch all...
  8. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    That's funny....no, ordered the kit about 3 days ago (just bought meaning recently), I also ordered some red colored boots too but did not use them. Installation took me about 2-1/2 hrs, had to borrow my buddies tool to pull off the fuel line which is like spring loaded, put some lithium grease...
  9. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    I just installed this kit minutes ago....a little bit of a pita but a little lithium grease on the new -rings helped for sure, and put them on both sides and then put the injectors and rail back in as one makes it easier. Will see how things go.
  10. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    28 yrs AF, now a DOD contractor....seen it/done it all in my career for sure as a Tactical Comm guy! Thank You!!!!!!!
  11. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    Just emailed him,,,,Thanks! ATK motor, military discount with timing chain cover on it and new oil pan, 1950.00 to the door on a tommy lift! 3yr/unlimited mileage warranty! 20hr job, no big deal! Figure I hope to run this Jeep another 100k miles plus with no car payment!!!!! Heck, 1950.00...
  12. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    I just bought the heat shield kit off amazon with fuel rail, injector, and bottom heat shield protector too! There is actually a TSB out on cylinder 3 injector because I guess it is too close to the manifold and fuel vaporizes! That will from what I read also tear up that cylinder so I did a...
  13. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    Curious, so what is so special about "wranglerfix" PCMs for the 2005-2006 Jeep TJs? What are they doing compared to flagship or the other companies? 1149.00, and if not the problem, a 20 percent restocking fee? Asking before I try what may or may not work.
  14. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    Did you pull the ODPA and check that and the cam shaft for wear? It seems really weird that out of ALL the codes a PCM could throw, why would it focus on the Cam shaft position sensor and a P0340 code? Who did you get your PCM from again? I heard wrangler fix is kind of proprietary? Can you...
  15. D

    2005 TJ 4.0 with P0344 camshaft position sensor code (anyone know where to get an OEM sensor?)

    PCM was replaced in 2017, seemed to work for a while, got from Jeep dealer-refurbished of course. So, what was your actual problem PCM or worn crank shaft or wiring?