Recent content by FeltonsPieceOfJeep

Good morning everyone. Just replaced a lot of things on the Jeep. Camshaft and crankshaft sensors, water pump, timing belt, thermostat sensor, thermostat and housing for thermostat. Took the Jeep out after all this and ran great for about 5 miles and then started sputtering around 2k rpm’s in...

Good morning guys. Have a little issue with the 06 tj 2.4L. Just recently replaced a lot of things on the tj. Camshaft position sensor, crank shaft position sensor, thermostat housing and sensor. The timing belt came off of the gear teeth and had to turning the motor over manually to get the...

Can someone please identify this part so I can replace it. I’ve search everywhere!! Recently replaced heater core and during the process I broke this piece removing the heater box.

I have some serious issues with HVAC. I’m pretty sure I need to replace my heater core but none of the controls work for the heat or a/c. I can hear it pressurizing but nothing blows out. I’ve replaced the resistor and blower but the problem may be the attached picture of a green plug in near...

I have a 06 2.4L and similar issue. Speed knob doesn’t work. Temp and setting knob appear to work fine. Could that be the issue? I can feel the heat but not blowing.

Everything checks out ok. I think I have it narrowed down to the switches that control the HVAC.

The wires look ok. Nothing fried or cut. I think that whole block just doesn’t work. Every other block works just not 5-8. Is there a way to just replace that block?

Ok update. I’ve traced the wires from the fuse box. No defects that I can tell. Everything that was attached to the blower motor and resistor or the relay is reading no volts on the multimeter. Volts are reading on fuse box #5, but still not to #8. Any other ideas on what to try next? I’ve...

I’ll check on that ASAP. I recently had to install a push button starter due to the ignition switch breaking again. Could that be part of the problem?

Need some help/ advice. Fuse panel under dash 5-8 is not getting any power. Bought a new blower motor and resistor.

Update on the piece of Jeep. Everything is working great!! Manually put the 4wheel drive back with a wrench and hooked the 4wheel drive connections back. Everything is great!! Thanks for all the help and advice.

I will try that tomorrow. And let you know. Thanks

That’s going to be my next step. I appreciate it.

Maybe the 4wheel drive is stuck?

No sir. Not in any gear.