Recent content by funmtbiker

Thanks dudes. I'll take it off tomorrow

I'm installing a currie/ Rock Jock lift on my LJ that I purchased about a year ago. When I added the springs, I put this rubber piece here back on top of the springs just like it was on the old springs. But now I'm thinking this is a coil spring spacer that the previous owner installed to...

this makes sense as well

This is the only answer that makes sense to me. With a 1 inch more radius ( and assuming the same tire width), everything is going to be one inch closer. So it makes no sense to me that you need 3.5 inches of lift for it to fit even under full flex. But basically you need that much...

I have a question about lift heights. I have a stock 2005 Rubi LJ, with the stock ~31 inch. I'm planning to install either a curry or metal cloak lift on and then larger tires. From what I'm reading it sounds like you need a 3.5 inch lift kit to do 33s, and about 4.5-5 inches to do...

40 minutes of full blast heater and then a hair dryer on the drip rail retainer to soften them up a bit did the job.

I'm gonna crank up the heater and see if that does it.

I need some help with my soft top. I've got a 2005 TJ unlimited I bought a few months ago. With the great weather we had last week I took the top down, now I'm putting the top up because of the coming rain. I've got the top fully up, with the header latches attached but but not closed, and...

yeah. I'm a friend of DS :cool:

Just last week I bought a stock 2005 47K mile Manual, Rubicon LJ in very good good condition for 9K less than this. I need to buy a top though. Edit: 9k Less, not 11k. Still a good buy at 16K though I think

Did you eventually sell this? If not I'm interested.