Recent content by Gropoto

Thanks for all your inputs, I’ll post my outcomes when I’m in completion.

Yes it is a Dana 35 and that is the plan of a plan of approach . The diff and axel seem to be a one piece, cannot be separated.

Thank you again, I’ll look and inquire a little deeper. By the way there’s no way to partially replace the shaft outer housing or is there?

Thanks PurpleTjaz, great infos. Yes I took a hit on the rear end of the 35in tire to rip out of the jeep breaking the axel shaft at the outer tip of the bearing and the seal. That tip is slightly bent about a little over a 1/4 in towards the rear. I am hoping to be an able to get by replacing...

Thanks Tj4jim, I’m just not sure understanding the pictures

Thanks Thanks, Thanks much for the reply. I must admit, I had watched this video before and see the tremendous difficulties about the task but remain hopeful that someone in the forum had handled it in an easier manner. Thanks!

Good evening to all jeepers! Hope I can get an idea on how to tackle the the removal and replacement of my TJ rear passenger corner panel, just the corner. I recently got struck and that panel there is sheared off along the rear bumper crown. Any input will be gratefully appreciated. Thanks!