Recent content by invmgmt

So...maybe I just noticed it, but when I have the fan control switch at the "panel" location, I am noticing air also from the floor vents. When I read the owners manual, it says that there will be some airflow from the window vent (defogger), but no mention of the floor vent. Any ideas? Is...

So, if it's not the Prestone one, where do you get the "Tees" referenced?

UPDATE: So here is where it stands; the p0700 went away after i removed and regapped the plugs and reinstalled the coil bar. However, the original error codes, p0302 and p0516, came back. I replaced the BTS but p0516 came back. Is it possible that the two (302 & 516) are tied to the same or...

I know this is old. But, seriously, no one knows the answer?

Battery reading is in the normal range, nothing out of the ordinary. I removed battery and checked the BTS wiring...didn't see anything concerning. I will check the resistance in the sensor tomorrow, maybe it's bad. Still getting reading p0302. Went away for a couple days after I changed...

Ok, so I travel back and forth from Chicago area to So Cal. The Jeep (2005 LJ) is in Chicago land. Typically,I leave the Jeep in the garage and take an Uber to the bus shuttle to O’Hare. Last time! Snowing and no Uber available. Had to drive to station and leave Jeep in freezing parking lot...

How do you get behind it? Can you go up from underneath or do you have to remove the entire face plate?

How do you get behind it? Can you go up from underneath or do you have to remove the entire face plate? I was thinking about installing USB outlets

Those are good looking rims

Great question. I have been driving the Jeep for about 6 months. Limited time really off roading in that time. Nothing would suggest that the prior owner had installed a lunchbox

So, last week I detected a faint sound like I was driving over gravel; just at slow speeds and usually when turning into a parking spot or something. Over the week, the sound seemed to become more pronounced, but not sure if that's just because my "radar" is up. I got under the Jeep to see if...

So where do people find longer M6 screws? Maximum length at HD seems to be around 2”

I know that this is not a "recent" thread, but what is the size of the screw you used when extending the snubbers? My experience is that most, if not all, screw/bolts on the TJ are SAE. However, when I took my existing screw into HD, it read as a M6. They don't stock anything longer than...

I know this thread is a little old, but what size is the snubber screw? It seems like most bolt/screws on TJ/LJ are SAE but when I tried to match this at home depot, it looks like a M6.

What a swinging deal. How did you learn that? I’m all in.