IOwnCalculus
TJ Enthusiast From AZ
- Messages
- 145
- Reaction score
- 148
- Joined
- Last seen
- Viewing thread 97-06 Jeep Wrangler TJ ECM / PCM Tuning Options
Latest activity Postings Images About
-
-
IOwnCalculus replied to the thread Viair 88p on ABS tray - have a couple questions.So far so good, but I also view it as "if it dies, it dies". If it ever does give up the ghost I'll redo it with a Viair actually... -
IOwnCalculus replied to the thread Front differential leak, should I just redo the RTV?.Thirded. They're reusable (within reason) and it makes future fluid changes much faster since you cut out the entire razor blade / wire...
-
IOwnCalculus replied to the thread Viair 88p on ABS tray - have a couple questions.I have mine hard-mounted to the ABS tray but apparently I've never taken a photo of it. I bolted it down, I want to say I used at least...
-
IOwnCalculus replied to the thread Weird electrical gremlin.To be fair, I discovered this a couple weeks ago when I hooked the battery back up on mine while the grille was still on the ground.
-
IOwnCalculus replied to the thread Weird electrical gremlin.The ground at the front left of the engine bay is disconnected - factory setup is a ring terminal on a 10mm screw going into the back of...
-
IOwnCalculus replied to the thread NV3550 replacement shifter options.The closest thing I have to a complaint about the B&M is that between the TJ and the Ranger previous to that, the only manuals I've...
-
IOwnCalculus replied to the thread Test AC Clutch / Compressor.Probably had a poor connection at the relay itself. The clutch needs a decent hit of power to actually pull in. I went chasing down a...
-
IOwnCalculus replied to the thread How to remove NV3550 shift lever?.I figured something like that would be the case. I can see a few ways to save the shift tower and sacrifice the shift lever itself, but...
-
IOwnCalculus replied to the thread Solved: Another Vibration over 50 mph after driveshaft u-joint change thread.I've never understood the thought process behind this. The driveshaft is balanced on its own, not with the yokes for the axle/case...
-
IOwnCalculus replied to the thread Is Bestop the way to go for a new soft top?.It's actually a whole $6 cheaper than when I bought mine in '19. Probably the only thing that would be cheaper to buy today than then.
-
IOwnCalculus replied to the thread How to remove NV3550 shift lever?.Did you ever find a solution here? I'm running into the same problem on the same repair.
-
IOwnCalculus replied to the thread Is Bestop the way to go for a new soft top?.The same Amazon listing I bought mine from in 2019: https://www.amazon.com/gp/product/B00DR1544Q/?tag=wranglerorg-20
-
IOwnCalculus replied to the thread Is Bestop the way to go for a new soft top?.Yeah, I'm at five years on my Sierra Offroad top and no complaints. The windows have started to haze over some but my TJ is parked...
-
-
Loading…
-
Loading…
-
Loading…