Recent content by Jake kozlowski

Good reads all around. Just got back from a glacier trip and it was roughly 10 degrees out all day. Highway speed cruising at 70mph I maintained 180f on the Murphy gauge. Now when I would park the jeep after wheeling and idling it would drop down to 125F. When the motor has zero load it's...

Winter months I struggle with temps. Ran it in -15 the other day and maintained 180 at 70mph! Now when I go off the highway I was right around 165 and idle dropped down to 120ish. I run cardboard but it only blocks off my radiator and still flows air across the Intercooler. No engine lights...

When are you coming back up?!

Just walked out to the jeep and snapped a few pics. So my harness was labeled with signal wires to a solenoid. Then one wire to grid heater and the other to the battery.

Yes, so the grid heater all I had to do was wire up. The block heater was extremely easy and I installed that when the engine was still on the crate.

Autometer responded... They want me to send the gauge and sender in...

I preemptively swapped sensors and still low reading. So I'm patiently waiting autometers response.

Hahah I did look up my gauge and the part number say F. Wrote auto meter and they requested i do a resistance test and my numbers are nowhere close... so possibly a bad sender?

Haha Thanks, I really like how it turned out!!!

It would be my luck LMAO

So my auto meter gauge shows roughly 100* when the Murphy shows 175* I'm thinking it's the sender since I ran a smaller one that didn't come with the gauge. My oil i went with mechanical. Only downfall is I have to run a PVC tube, but it reads something other than the 44psi that the Murphy...

So I mounted my ox locker shifter next to the shifter. Plus I really like the Murphy gauge! Fun to check engine load, plus it's my main coolant gauge until I figure out my issue with the other one.

Thanks!! I need to figure out why my 4wd light, reverse lights aren't working, and also why my temp gauge is reading low.

Still a ton to finish up! Here is some updated pics. Also, the driving is awesome! Just taking time to break all the new parts and make sure these gears wear in properly until I have some fun with it!