Recent content by JEEP GC

We just replaced the AC compressor on the TJ and system charged with no leaks. The problem we are having is the the AC only blows cold through the defrost windshield ducts. No air flow through dash vents. Any thoughts on a fix? Maybe faulty controls? Vacuum leak?

Would anyone know if a 1997 TJ 4.0l 5spd transmission fit into a 93 YJ. If so are there any modifications that need to be made. Thanks

OK Guys...Dropped a spider gear on the concrete and failed to notice a fracture before I installing it. The spider broke causing damage to all the gears including the pinion and open carrier. After recovering from my emotional break-down I find myself in a re-build funk and need opinions and...

Roger that...Could you tell me how difficult it is to replace the pinion?

DIY install. see one of my other replies with what I think happened.

My mistake. The new shaft went in with the SYE install

Did not change R&P as they were perfect the 1st. rebuild. On the 2nd. failure the ring is perfect but there is a small nick in one of the gears on the pinion. We did realize that one of the large spider gears were dropped on the floor prior to install which tells us that was the problem which...

Could it be that the 33's are just too big for the Dana 35 3.55 and the size is chewing up the spiders?

You guys have been extremely helpful on my journey with the TJ rebuild so far but NEED ADDITIONAL HELP 1997 TJ 5-Spd 4x4 Background: Recently installed a RC double cardan drive shaft and a drop spacer (to drop skid plate under trans). 33's with a RC 4" lift Everything ran perfect....for...

As usual guy...thanks for the guidance !

Recently installed a new S&J 4.0L engine in my 1997 TJ 4x4 5-Spd. Used their recommended break-in oil for the 1st. 500 miles. What oil should I use after the initial break-in period...Thanks

I pulled out the transmission from my '97 TJ 5-Spd 4X4 and replaced it with a new AX-15. The transmission had 250,400 miles on it and it was working fine before pulling out. We went with a new unit because we installed a new crate engine and figured..."what the hell", why not replace the trans...

Rebuilding my TJ rear differential with all new parts (carrier, spicer gears and ect.) When I cleaned out the housing I noticed a red rubber O-ring on the opening that the axle slides into. The O-ring was shreded so I picked out the remaining pieces. Been trying to find the part # for...

OK then...what does one use to change a flat tire on a 4" lift with 33"?