Recent content by jeepinit

Normally it doesn't sit, in this case I was out of town for a week and it was parked in the garage.

Forgot to mention - 51k milage. She was running great and then sat in garage for a week. Then i got the 344 code and the gages all died and then the jeep died. Started back up and then limped and died several times. I got the 334 code and a u0155 code. Thanks again!

I am replacing both my camshaft and crankshaft position sensors on my 2006 4.0 6sp manual. This seems to be pretty straight forward, the question: is this just R&R? Seems I read something about they have to be synced? Any guidance here is greatly appreciated! Thanks in advance!

I sent them a message, this may ne the part I need. Thanks!

Thanks Mac!

I purcjased a used hardtop and the bottom trim piece on the rear glass is broken. Anyone know were I can get this piece from? TIA!

Hoping for a little guidance with my 06 tj. I've only had it about 2 months now. Driven on freeway cruising at 75mph for miles. Has 49k miles on 4.0 6 spd manual. Rust free. 2 inch lift I believe. I had a slight shimmy in the steering wheel at 50 mph, not before or after so I had the front tires...

Hey fellow jeepers! As a newly anointed tj owner, I am trying to figure out my blowe control knob. The first two points don't actuale the fan, the third and fourth are great. Anyone have any ideas where/how to trouble shhot this? Also, one of the plastic directional interior vents is on far...

Bought my tj about 2 wekks ago, 49k on it.My It pulls left when braking. Front pads are fresh, sliders lubed up. It jas rear disc brakes the pads in ok shape. New shocks, suspension parts are good, Any one have any direction I can look in. Thanks in advance!

I see, makes sense. Ordering these now. Thank you!

Very nice to know this, Thanks Brian! I do jave to ask - you say 1/4 inch drive? This was able to break those lose? I will be order these tools today!

So I had some success with my rear shock upper bolts, key word - some. I had one snap off. Passenger side out board. Now I'm wondring, drill and ez out, or pull the wheel well cover and maybe get vice grips on it and turn it on through the top. Anyone have any thoughts on this? Thanks in advance!

I can't seem to find your build thread, any assist be appreciated!