jjvw's latest activity
-
jjvw replied to the thread A rebuild of #miRustyJeep....No pics, but I think mine is ending up in the same spot. The two thick bundles pass down next to the trans fill tube against the... -
jjvw reacted to Rickyd's post in the thread Anyone have any experience with these PowerStop brakes? with
Like.
Powerstop isn't an upgrade.any of these choices are though! https://www.shop.blackmagicbrakes.com/Jeep-TJ_c32.htm -
jjvw reacted to Rickyd's post in the thread Anyone have any experience with these PowerStop brakes? with Like.
Even better https://www.shop.blackmagicbrakes.com/VANCO-15-Big-Brake-Kit-with-BMB-Pads-for-15-Rims-BBK-NDM15.htm
-
jjvw replied to the thread Bumper ID? Chinese made?.Several years ago, I found over ten brand names of that very same bumper. Somewhere in China sits a enormous pile of them waiting for a...
-
At page 12.oh boy this is gonna be a long read. Gotta check out blaines stuff too
-
jjvw replied to the thread Savvy Mid Arm Axle Side Bracket Positions Needed.Iron Rock off-road sells a pair of lowers that are a thicker version of stock. Another reason Artec mounts are dumb is that they create...
-
jjvw replied to the thread Daily Driver, Go Where I Want To Build.6 hours and one call to Blaine and the automatic wiring harness is installed. Getting closer to the first fire up!
-
jjvw replied to the thread Opinions wanted on rear diff options.Shhh. Don't say mean things about the 8.8. It hurts people's feelings! 🤣
-
this.if all they did was pop the spider gears,disassemble it clean it very well with lacquer thinner and compressed air. Then replace...
-
jjvw replied to the thread Opinions wanted on rear diff options.Repair the 44.
-
jjvw replied to the thread Savvy Mid Arm Axle Side Bracket Positions Needed.Your goal is to preserve caster throughout the suspension travel and make sure the upper arm doesn't crash into other things.
-
jjvw reacted to carrotman's post in the thread Savvy Mid Arm Axle Side Bracket Positions Needed with Like.
Thanks again @jjvw for the realization that it is a parallel 3 link with equal length links. I did some measuring with lasers to see...
-
Picked up the work bench last night. It's 5/32 thick, so a little lighter than I anticipated. I think it'll be OK for what I typically...
-
OK.... Again you have your reason for running what you do. You can find fault in anything just like anyone else can. So with that Bye Bye.
-
jjvw replied to the thread Explorer 8.8 diff offset.Anyone stuffing anything larger than a 35" on an 8.8 (that is already too narrow) needs a wider axle. The whole point is that some...