Recent content by JustDandee

Looks like it’s a partnership with Conrad. The stations is a Conrad & Bischoff but looks like that partnership map is a weee bit out of your area. https://conradbischoff.com/

Strictly suspension lift for shock lengths. The shocks are using an axle mount to the frame mount location. The upper mount is not to the body so that portion of lift does not factor into the equation. If you feel inspired take a tape measure out - down and dirty you measure a static length...

todays look on Idaho...

^ thisis probably going to be the truest statement on this forum today. I suspect that 98.27% percent on this forum are running these with smiles per mile….and money for another upgrade.

You know you could order a replacement set through Amazon…..to soon?

Oooff …that is significant upcharge…. This station I have close by is closer to the .30 -.40 cents range. I will have to pay closer attention

https://www.desmoinesregister.com/story/money/agriculture/2024/04/19/summer-e15-ban-dropped-under-pressure-from-iowa-other-ethanol-states-reynolds-ernst/73383808007/ Cheaper gas-well for the Midwest states. I think the farm lobbyist are happy… corn farmers… a few congressman…but if it were my...

For consideration..Other side load ideas I think exist

Don’t have your configuration but for some context back in the late 80’s used hang with a group that put anywhere from 35’s to 44’s on Toyota pick-ups. Most of us stock axles other than lift springs… meaning you can run what you got.. could it be better? Yes. Keep the auto transmission in a...

Option A please….

Thought the same thing, lots of good photos submitted!

Transitioning into warmer weather mode, last year for this top I think. Anyone do a good job on these corners? Make a rear window that is easier to open... I believe this is the factory top. it just may shrunk over the years. Can not get them weathertight close. going to have to zoom in...

Well if we are going to have a proper conversation restarter…How are y’all running the wires to that location? I like the side LED shooters at this spot but wiring like I did was Uber tight going through the cowl - concerned vibrations and the pinch will sever the wire.

2" JKS springs- closer to 2 1/2"- 33x10.50x15's w 1" wheel spacer- swaybars connected... never rubs. server is not letting load pictures....