Recent content by jxv1247

Mount it, you wont regret it

Some great trails back in there ! That’s the usual go to spot for me . Was last in there with my 40 series. (Sorry not a jeep photo unfortunately)

Got them for a deal. Buddy ordered them and never used them

I had the PRP enduro reclining seats, these master craft have much more support than those did. For an every day driver the PRP were great however.

I had PRP and now master craft. I like the master craft more.

Safelite replaced my rear hard top windows and I’m looking to toss it on now that it’s winter . I noticed the mount for the struts does not have the rubber washer between that and the glass anymore . Does anyone know what size rubber washer that would be ?

girlfriend got me a jks ogs128 front track bar as one of the gifts this year , tossed it on. I don’t think it’s driven this well in a while. No more rough country front track bar.

In need of a new front track bar and Clayton is local to me. It appears their system uses a drop bracket along with a drop pitman arm . It seems like they have been using this setup for quite some time. Is there any real downside to this besides bump stop extensions (already have 3” extensions...

Selling my spare Adams driveshaft for a slip yoke eliminator. Measurement from yoke to yoke according to Adams measuring chart was right at 16.25". I had it made for my 98' on a 4" lift and a dana 44 rear end. Only have about 2000 miles on it and always kept it greased. Looking to get $150...

New pinion bearings in the 30, man was that crush sleeve a pain in the butt to crush in a gravel driveway . Oh and it drove for the first time in a bit

Went to toss new springs and pins in my Aussie locker and figured out my pinion has some play. Looks like I’ll be tearing the pinion out and doing bearings this weekend …. Fun fun fun

Where did that boot come from ?

Fair point, BMB tie rod it is

Joined the bent tie rod club a while back and am finally getting around to replacing it . Looking at 2 options , the TMR 7075 one or the black magic 4340. Anyone have any experience with the TMR one? Only coni can think of to the aluminum is the larger diameter for diff clearance. Tie rod in...

I have not, but it's worth a shot !