Latest activity Postings Images About
-
-
kam04LJ replied to the thread Work from home LJ.Dog is enjoying the jeep. He’s been cruising around in the back. -
-
kam04LJ replied to the thread Revolution Gear Question.Revolution sets up great. Did a thick 5.13 set 18 months or so ago. Good luck and I’m sure everyone here will help as much as needed to...
-
Thanks, doing revolution 5.13, will install run a pattern and go from there. Thanks again.
-
kam04LJ replied to the thread Work from home LJ.Another 500 or so miles down. Jeep is doing great. Had an issue today I can’t reproduce and am laying in bed thinking about...
-
kam04LJ replied to the thread Louisiana Red Rock Hemi swap guides.Yep I haven’t done the swap yet but couldn’t imagine doing it without the guide. It’s worth it
-
These are worth their weight in gold if you are considering a Hemi swap into a TJ. Absolutely worth what Lowell is asking.
-
kam04LJ replied to the thread Work from home LJ.I picked up a few pack out pieces and am decently happy with the setup so far. Like anything, I’ll dial it in over the next few weeks...
-
-
If only their stuff was yellow…🙁
-
kam04LJ replied to the thread Work from home LJ.Changed fluid in both diffs after initial 500 mile break in. Fluid looked great. Gears are dead quiet and ready to rock and roll. I am...
-
kam04LJ replied to the thread Which gears should I go with?.I have 35s with 5.13s and would want more gearing if it was available. Most people here will share same sentiment.
-
I have a 03 5spd 4.0L on 35s but I only have 4:88s and its alright but if I were to choose again right now I would choose 5:13/5:38
-
+1 for RGA whatever you do don't get Yukon
-
Yes, but why? That would require at a minium a new carrier and setting the gears up again. If you're paying someone for that, it will be...
-
Are you including the hood with "the body"? FWIW if your rear axle is set up right on 35s, you most likely already need to cut the body...
-
kam04LJ replied to the thread Work from home LJ.yeah. It is set up right and could use some “persuasion”. I’ve held off doing it so far but will have to.
-
-
Loading…
-
Loading…
-
Loading…
