Recent content by Kraken72

So recently acquired a hardtop. Want to sell my one month old Besttop Sailcloth soft top with factory frame and hardware. What would be a good selling price?

Well I found a forum member parting out his TJ and bought the cable and control panel from him. Got lucky.

Well I guess mine finally dried out. I went over the wiring and pdc. I also had a loose connection at the starter relay in the pdc, that led to a no start condition. I have not any problems since.

Hello again. I have just 31" tires on a jks 2.5 inch lift. Factory 3.73 gears and run about 1800 rpm at 55 or 60mph. I don't need to go any faster. Avg 15mph.

Well contacted bestop, sending me a new top minus windows.

Heat is no problem here in Louisiana it's almost 90 degrees and 78% humidity. But it seems like the tab is almost too long. It goes in but does not give a positive snap. It's still holding for now, but it has a bend in it. Only time will tell. I have a fender from my utv that is thicker. So...

Appreciate all the input. I tapped down the tub rail with a rubber mallet. Straightened out the black tab. Reinserted and so far so good. Hopefully it stays like that. If that does not work will modify the stiffener. The other side has the same design, but it's not backing out.

No I haven't, it doesn't seem to be in the way. The black tab is bending and I think that is the problem. I am going to try to tap down the lip on the tub a bit to see if it will hold.

Got a UAC EV4864999PFXC to give a whirl. Looks like the same one Jeep Air Sells. Got pretty decent reviews on Amazon. RockAuto is the cheapest. I replaced my condenser with a UAC one and it's good so far. Unfortunately my Evap is bad so dash removal soon.

Nevermind figured it out Thanks

It's a stiffener of some sort.

Yes it tucks in, but slowly pulls out.

Contacted Quadratec, they said they don't see anything wrong. But yet the corner keeps popping out. Will try to contact BestTop. Not too impressed right now. Probably will have to just repair it myself.

Stiffener is fine. Black piece in second photo keeps coming out.

Nah it's fine. The tab keeps popping out. If Bestop will not warranty it, I will just cut a piece of 5 gallon bucket to match an drill holes and sew it by hand.