LJGreg
TJ Enthusiast 47 From Pitt Meadows, BC, Canada
Latest activity Postings Images About
-
-
LJGreg replied to the thread 7 Pin Towing connection.Those type have an accelerometer built in to detect when the vehicle is braking and then applies appropriate brake to the trailer. It... -
LJGreg replied to the thread 2006 Rubicon Front Pinion Nut.What about me? 😂
-
LJGreg replied to the thread 7 Pin Towing connection.I don’t believe TJ’s ever came with brake controllers so your electric brake wire is likely not hooked up to anything. You would need...
-
LJGreg replied to the thread 2006 Rubicon Front Pinion Nut.If he has a rubicon as mentioned in the thread title, wouldn’t that mean he has a Dana 44 so shims not crush sleeve?
-
I wanted to follow up after a bit of a delay; it seems the post office has been running slow in my area and I just got the pinion seal...
-
LJGreg replied to the thread Which Black Magic Brake kit do I need?.@JEEPSTEVENANAIMO, you may already know this but Point Roberts has a few parcel receiving services that charge a small fee. It's like a...
-
LJGreg replied to the thread New Revolution Shafts Seem Too Long?.Success. As Blaine mentioned, I confirmed it wasn't the ramp up section that was making contact so just used the bandsaw to cut 1/16"...
-
-
Where is your brake dust shield/ backing plate?
-
Is the end of the shaft hitting the pin in the diff? If it is you can trim the end of the shaft to get the length you need. But, I...
-
Depending on what your locker shim stack needed to be, it could have moved your locker closer to the driver side.
-
Put the dust cover back on
-
Put the dust shield back on, that buys you .035 and then cut 1/16" off of the end of the shaft and deburr. We do it all the time...
-
LJGreg replied to the thread New Revolution Shafts Seem Too Long?.Thanks guys, I totally forgot about the dust shield but even with it, it is still tighter than I would want. I'll check the seal and...
-
I'm rebuilding a Dana 30 HP out of a 1997 XJ. I have installed a ARB RD103 locker (30 spline) and am using Revolution shafts...
-
-
LJGreg replied to the thread WTB: Kenwood TM-D710GA.Cool, thanks for the advice. I'll keep my eyes open for a non G as well.
-
-
Loading…
-
Loading…
-
Loading…
