LONGJP2's latest activity
-
I really enjoyed the section on how the hole size relative to fastener diameter plays a huge role in how to design a slip critical... -
LONGJP2 replied to the thread Front bumper bolt size?.The length you'll need is the length you have plus the thickness of the hooks you buy. ;)
-
LONGJP2 replied to the thread How to Troubleshoot the Factory CD Player "ERR".The CD player is the first to go. Too much dirt gets inside.
-
You can also relocate your fan shroud to bypass the MML, you just won't get the benefits of the driveline correction...
-
LONGJP2 replied to the thread Factory Fog Lamp Wiring?.Driver side or passenger? Could be a temp.sender plug.
-
LONGJP2 replied to the thread Alternate recovery options?.Simple; don't go wheeling alone.
-
LONGJP2 replied to the thread Quick question for those people who installed Derale coolers.I didn't follow the line routing directions on mine. However, IIRC, they aren't connected to the line bracket itself. You can put it...
-
LONGJP2 replied to the thread Midnight LJR Build.What about a snap kit...
-
LONGJP2 reacted to mainegoat68's post in the thread Yes, still another death wobble question with
Like.
Well it's been a couple of years now, I don't drive it very often, and I wanted to make sure it was gone for good, before I posted this... -
LONGJP2 replied to the thread 4WD shift linkage doesn't go into 4-low easily.Are you saying the shifter handle (in the vehicle) won't move through its range, or the shifter linkage on the transfer case. Either...
-
LONGJP2 replied to the thread What's a good hardtop hoist DIY frame?.Harbor Freight winch. ;) Same one I had up in the rafters of my old house.
-
LONGJP2 replied to the thread What's a good hardtop hoist DIY frame?.Here's a few pictures of my current setup.
-
-
5.38 was a good choice. For 35s, shaft-wise, I'd upgrade the front shafts to 4340 chromoly. The parts on the front shafts that hold the...
-
LONGJP2 replied to the thread TJ hardtop bolt attachment upgrade.I use C-channel nuts that are attached with silicone adhesive under the rail. Now that I know it's a JK thing, I'm going to rip them out.
-
-
LONGJP2 replied to the thread Help me install my lift.If the shaft is spinning, more torque isn't going help. 1) Did you try holding the round plate just below the bushing? It's usually...
