Recent content by MuffinMan1234

The problem I found was one the wires into the switch wasn’t all the way in. It was like a pinkish wire for me

Wires are in a pretty good condition. No rust, cuts or tears. Bosch and i bought them pre gapped

My engine started misfiring awhile ago and i havent been able to fix it. It only misfires when moving not when its idling. I changed the ignition coil and spark plugs.

i used a rough country lift that came with springs, body mounts and shocks. if i go over 40 Mph it death wobbles badly not uncontrollable but to where i have to slow down or come to a complete stop to continue driving and i went to a shop to get an alignment and thats what they told me exactly...

I recently lifted my jeep 3.75 inches and now I death wobble. I found out that the problem is slack in the track bar and in the gear box and needs upper and lower radius arm bushings. what would be the best and preferably cheaper way to replace or fix that?

Thats exactly what I wanted thanks

Its located in the center console and its powering 4 speakers. 2 in the front and 2 in the back.

I have Speakers set up alrighty but they are just sitting in the trunk taking up space.

I have an aftermarket stereo and amp.

I got a speaker bar shell and i wanted to know what would be the best way to go about wiring it?

My front wipers stopped working and I couldn’t figure out the problem so I replaced the wiper motor and switch and it still doesn’t work. Fuses aren’t blow and look good.

I installed a new turn signal switch and my windshield wipers stopped working but I don’t know how to tell if it’s the switch or the motor. I added a picture of the switch.

I had high idle so i went to check what the problem was and i found this open vacuum port on the intake manifold. Does anyone know where this goes?

I bought this engine from a company that's supposed to be "refurbished" but the intake valves are rusted and a buddy of mine told me that this engine is toast so I'm here for a second opinion. Will this engine run if i just throw it in?

What size are they and if I were to replace all the lines how much feet is that?