myjeep3
TJ Enthusiast 40 From MA
- Messages
- 688
- Reaction score
- 269
- Joined
- Last seen
- Viewing thread Building a tire carrier for a 35 inch tire
Latest activity Postings Attachments Images About
-
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.Yes the hinge has bearings. Here is an image of the bolts am talking about. -
-
myjeep3 reacted to AirborneTexasRanger's post in the thread Building a tire carrier for a 35 inch tire with
Like.
I would use the 2 angle pieces & top flat plate like I mentioned before. It's hard to give you a definite answer because this type of... -
myjeep3 reacted to Apparition's post in the thread Building a tire carrier for a 35 inch tire with Like.
Although I’ve since sold it my metalcloak tire carrier bumper was very solid and rattle free. It was also expensive, overbuilt and heavy...
-
Reread what Blaine said in post 21. That encapsulates this entire endeavor. In all my mulling over of this project, everything keeps...
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.Trying to understandnas as I go. :) was going to use the plates cause am thinking that the metal (1/8) where i will weld the pivot...
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.I can put the first 2 inner bots without sleeves? I feel like the 2 outer, and bottom bolts are doing all the work. Also not sure if...
-
-
Mine has a lot less going on than yours. Are fourteen attachment points too many?
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.I did just that. Wasn't too bad. Should I weld these flat pieces at the badck and front of bumper? Is that needed?
-
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.I have those installed. Thanks. Are the other 2 inner bumper bolts needed? The metal at the crossemember is thin there
-
myjeep3 reacted to basedbb69's post in the thread Building a tire carrier for a 35 inch tire with Like.
https://www.amazon.com/dp/B07C3J98QJ?tag=wranglerorg-20 Tie in brackets Skimmed over this thread so I might have missed it, but if you...
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.Ok thanks. How else can i install the bumper bolts so that I don't have to sleeve the bolts holes? Was thinking of opening the back...
-
myjeep3 reacted to AirborneTexasRanger's post in the thread Building a tire carrier for a 35 inch tire with Like.
Use a flat plate on top & a piece of angle on the bottom
-
myjeep3 replied to the thread Building a tire carrier for a 35 inch tire.I can do that, but then bracket for the pivot hinge is shorter thn the bumper, so that flat plate at the bottom won't go across like the...
-
-
myjeep3 reacted to AirborneTexasRanger's post in the thread Building a tire carrier for a 35 inch tire with Like.
Is that bracket tacked to the tube going to be your pivot point?. If so just put a piece of 1/8" angle on the back side & some 1/8" flat...
-
Not worth the risk... But you can look under your tub and see how much room you have.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
