N
Nutro
Member 46 From Austin, TX
Latest activity Postings Images About
-
-
NNutro replied to the thread I need some help with MFS fuse blowing.Ok so interesting. I went to Autozone and bought a new EP27 LED flasher and installed it and a new 20A fuse under the hood. Turn signals...
-
NNutro replied to the thread I need some help with MFS fuse blowing.I'm not the greatest at wiring/electronics but I pulled the flasher relay from the column and it is a EP27 LED flasher. I tested it and...
-
NI'm about to pull my hair out. OK! So, 2004 LJ with LED rear tails but has some diode dynamics inline LED "filter" of some sort wired...
-
NNutro replied to the thread Does anyone still sell these LJ cab covers?.I didn't even know there was a part number so thanks! But yeah, looks like they are long discontinued.
-
Ndoesn't appear so: take that one to a local upholstery shop and see how much they charge to re-create it
-
NI know the RainGear one exists but I can't afford it. I have this Jeep branded one but it's seen better days. I googled and don't think...
-
-
NNutro replied to the thread A good engine ground?.I guess I should dirty delete this to save face? Haha I finally got to drive it. With the aux cooler she doesn't go over 140 degrees...
-
NNutro replied to the thread A good engine ground?.Well, so I started the Jeep and let it idle for about 10 minutes while putting in drive and back to park but the gauge never moved. It...
-
NLocated in Austin, Texas. Would rather not ship. Yes, I know the internet is full of scammers, I bust tons of them in the Facebook...
-
-
NI'm installing an autometer trans temp gauge and it says to use a good engine ground. I went ahead and just grounded it on the transfer...
-
NNutro replied to the thread Does anyone know what terminals were used in the headlight plugs?.I just went to the local Toyota place and picked up my harness and lights. I forgot all about those. Going to order a few more for...
-
-
NNutro replied to the thread Can I use RTV on the transmission pan gasket #5 hole?.Well, it's installed. I just used a little blue loctite at the end of the threads and a little grey high temp RTV under the bolt head...
-
NNutro posted the thread Can I use RTV on the transmission pan gasket #5 hole? in TJ General Discussion.On my 04 I am about to put my Dorman pan in that Blaine bunged for me. I bought a Lube Locker gasket. On that number #5 hole, can I use...
-
-
NNutro replied to the thread Does anyone know what terminals were used in the headlight plugs?.Thanks! I think I have some 56 terminals in my box. I was curious about the plugs. One side is 2 wire and the other is a 3 wire. Both...
-
NNutro reacted to Daryl's post in the thread Does anyone know what terminals were used in the headlight plugs? with
Like.
They’re 56 series. You have two areas of concern. your wires are corroded pretty far back. Also since this is the drivers side plug you...
-
-
Loading…
-
Loading…
-
Loading…
