O
Reaction score
30

Joined
Last seen

Latest activity Postings Images About

    • O
      Offwidth replied to the thread 06 red LJ.
      I have decided to make use of UCF engine skid by cutting it up and bolting to the stock crossmember. Ridges on the stock transmission...
      • IMG_8513.jpeg
    • O
      Offwidth replied to the thread 06 red LJ.
      Installed stock transmission skid, obviously being non aftermarket part tons of clearance with large oil pan. Drilled UCF belly...
    • O
      Offwidth replied to the thread 06 red LJ.
      I am thinking of an idea. Could take stock crossmember, and use this skid with it by cutting side bender around the crossmember and...
    • O
      Offwidth replied to the thread 06 red LJ.
      Don’t mind hangers in non recommended positions, I was playing around with angling it to work. Problem on my end is the gigantic...
      • IMG_8491.jpeg
    • O
      Offwidth replied to the thread 06 red LJ.
      I have failed to install Undecover Fabworks aluminum engine skid. It is too narrow under my transmission oil pan. Trimming side...
      • IMG_8490.jpeg
    • O
      Offwidth reacted to Wildman's post in the thread 06 red LJ with Like Like.
      If it makes you feel any better I had to clearance my skid also. I have a 46RE behind a Dodge Magnum V-8 and a 1.25" body lift. I do...
    • O
      Offwidth replied to the thread 06 red LJ.
      Those oily stains are from CorrosionX HD. I put this shit on everything after putting together. That said I marvel at complete lack...
    • O
      Offwidth replied to the thread 06 red LJ.
      Had terrible time trying to mount pan until I realized that I have changed motor mount when everything was disconnected and my driveline...
    • O
      Offwidth replied to the thread 06 red LJ.
      Added washers on the transmission mount bolts and to the plate between them to get some extra clearance. Hopefully I don’t need to go...
      • IMG_8470.jpeg
    • O
      Offwidth replied to the thread 06 red LJ.
      I am wondering what would be safe clearance to allow for transmission mount elasticity and future degradation.
    • O
      Offwidth replied to the thread 06 red LJ.
      It ain’t super precise, but hopefully should clear and not hit oil pan when I high center. Hopefully.
      • IMG_8469.jpeg
    • O
      Offwidth replied to the thread 06 red LJ.
      Probably some use of grinder. And die grinder to cut a bit off oil pan cooling ribs.
    • O
      Offwidth replied to the thread 06 red LJ.
      The joy of vendor incompatibility continues. Underground Fabworks belly pan, ostensibly one not requirimg MML and stuff, happily...
      • IMG_8456.jpeg
    • O
      Offwidth replied to the thread 06 red LJ.
      I am not going to use an extra one right now. ATC Diesel folks had been ok with that as their large oil pan and better oil pump and...
    • O
      Offwidth replied to the thread 06 red LJ.
      Also since I was at it, replaced all oxygen sensors with whatever NTK this forum suggested. Also touched up frame rails under belly...
  • Loading…
  • Loading…
  • Loading…