Recent content by Pascal25

Adjusted my rear pinion angle from +1⁰ to -1⁰ for the driveshaft, put the winch and fairlead bracket (thanks Harbor Freight!) onto the bumper, and now have found that the bumper interferes with the stock sway ar bushings 🙄

Thank you for the detailed and thorough writeup, I'll be sure to refer to it when doing this

Now kicking myself for not realizing/remembering to get a fairlead bracket ordered along with the bumper and winch, so there's nowhere to mount the included warn hawse fairlead.... Not great timing when I'm going up to the UP Wednesday 🥲

Looking at the condition of one of those bolts, I consider myself lucky and thankful that I remembered to bathe it in Kroil a few times in the past days

Bumper bolts came out a little easier when I switched to a fully charged battery in the impact!

Fixed (at least after checking with a test drive) the leaking oring of the sensor of my new SYE. Also began removing bolts for swapping the front bumper. Going to let bottom two bolts soak a little while longer...

2005 2.4L, ~27", round head, PN 53010494AD

Thanks I thought so too

Started painting my new Artec front bumper and installed my new DC driveshaft after completing the lift. Almost "done"!

I saw that there's a bracket for the one in the tub, but what about the one in the tailgate?

Started on this before going away for the weekend for work. These two look like good candidates for welding on a nut to remove?

First transmission fluid change under my ownership. I need to work on my technique refilling so I don't make such a mess. On the bright side, the garage floor isn't going to rust any time soon (neither will my arms)

Savvy cable shifter and new half door upper skins

Me? Accepting it for how it is and enjoying the ride. Doing everything I need out of it

Have you tried swapping the plug from cylinder 1 with any other to see if the error follows it? Or a wiring fault related to the plug or injector on cylinder 1? Additionally, after replacing cam and crank sensors, did you perform a relearn with a code reader or by disconnecting the battery cables?