Recent content by Raul G

I adjusted the intermediate band, since then it’s gifted much better but I still continue to get the excessive shudder when coming to a stop. The only solution I’ve had is throwing the gear into neutral then to drive again. Seems like it allows it to down shift and avoids the shuddering. Any...

Thanks truly appreciate it!

Thanks, jerry I am not sure if it was atf+4. I will take a look at my receipts. Incase it was not the correct atf, would I just drain it and replace it? See if taht may be the problem.

Hello Jerry, you seem to know more about the TCC. My Jeep 4.0 3 speed auto used to shift ver well the tcc would engage at highway speed but after replacing the oil it started to act up. It will not engage the tcc at highway speed. And shifts at higher rooms than normal. There was also a short...

What issues are you having?

Were you able to fix it? Or find the culprit?

Thanks I’ll go ahead and check tomorrow!! And check back to see what I found!

So a while back I had replaced the blower resistor on my Jeep. It would only work on a certain level witch was low, since I replaced the blower motor resistor it worked like new. This morning my Jeep would not blow any air in any level. I piped the hood open and checke did the clutch was...

Thanks for the reply!!

Did you figure out the problem??

Thats what it looks like when I spliced it to the connection.

I bought a 98 tj and it came with what I believe are the stock fog lights. They did not work so I took them off and it turn out taht they both work but the only problem was taht the wiring was not set up correctly. I’m a nubie to electrical and just wanted to confirm if this is how you are...