Recent content by reconeTJ

Hi guys, I have a 2006 tj rubicon,have 2 inch lift, 33s, replaced front ujoints, rear driveshaft ujoint, new shocks, new rear sway bar. For some time now I have this annoying clunking sound that comes from drivers rear side on the axle. So every time I go over a bump, I hear clunk clunk...

Hello fellow jeepers, I developed a squeek from my rear drive shaft and it got me worried, I jacked it up and I was spinning the driveshaft and it kept squeeking. Here is the video that I have. What do you guys think I should do? Link-

After replacing tyranny mount and using a 1inch spacer it have gotten worse, but it's the exhaust that is transferring the rumble all through my frame, goes away with high rpms, comes back at idle and low rpms, plugged cat probably. But I think I'm 99 percent sure! Thank you all for suggestions

I appreciate all your responses, work week started so I will have lest time to check all this, but this is the best community in the world. I have quite a few things to check and will report back!

So I noticed that my 2006 4.0 has a little shimmy or light shake at idle every 3-4 seconds, so I decided to replace all the sparkplugs, now the new ones are in and RPM gauge is perfectly still, so no fluctuations. Engine motor mounts seem solid so does the trans mount, I have a new one just in...

Great comments guys, thanks for posting pictures, I'm getting a better and better idea what I want to do

I got this nice 2006 rubicon that I installed a 2 inch coils+shocks lift, I'm running stock moabs 16 inch wheels. Now I'm looking to get into a bigger tire and u was looking at 265/75/r16. So I also have a 1 inch body lift that I bought. These days it's hard to find a good tire that's available...