Recent content by Rescue6

If I wouldn’t have to lay in the snow to get an actual measurement for you at the moment i would. But just off the top of my head from memory the skid is roughly 2.5”-3” wide and I’d say 3/16” thick. My has held up great and been drug across all kinds of rock. I have replaced the bolts that hold...

So the check gauges light came on and everything looked fine except the voltage. Got home checked the battery voltage it was fine roughly 14.5v running and 12.4 not running. Took the battery and alternator to the Napa both tested fine. Cleaned all battery cable connections and tightened at all...

Anyone installed or used the Undercover Fabrication part # UCF394. “The Jeep TJ Parking Brake Bracket Kit was designed to mount a Wilwood master cylinder in place of the factory e-brake bracket on the TJ. This is very helpful in performing axle swaps with rear disk brakes. It will plumb...

Anyone have accurate info on how much the Currie Rockjock bumpstops model CE-9122F compress under full stuff conditions. I know I measured metal to metal with the factory bump stops but I’m looking to get the rockjocks up front and want to make sure I set them up correctly for the 12” shocks as...

Looking for a bestop door surround the type that has the pins that latch for the sun rider portion. Only need the passenger side but would buy a pair if needed.

I’m looking for a Passenger side full door or a pair of full doors. As I flopped it over and destroyed my passenger door. I’m in Colorado.

That will leave a hole.

I keep one of the bushings from the “Help” section at the local auto parts store in my glove box. Get a new one when I swap it out. I have it down to under a minute

I’ve battled this for years. I keep a new bushing in my glove box. I have to change it out once or twice a year. Never had it happen as often as you fortunately

Genright offroad will do there Tj to Jl conversion for you they just started offering. And are located in SoCal

I am 6’5” also. Once I put my PRP seats in. I sourced a non fold and tumble seat bracket for my drivers seat. Then took 1.5” out of it.

Great shots.

Absolutely I’d love to get out to Moab along with you guys sometime. You always do such a great job of capturing shots and narrating them. I wish I remembered to do that on all my trips so I can enjoy the memories later on.

I only have a soft top so not sure. And mine is a 1999 so no inner frame trim panels either. Sorry I can’t help you.

I wasn’t matching anything I just had them done in black like my rock sliders.