Recent content by Revenant4x4

A while back i was debating on doing a diesel swap. Well my 100k 4.0 threw a rod at the moon, so im cannibalizing all of my parts, and building my jeep from the ground up. The plan is cummins r2.8 diesel engine, tr4050 5 speed, atlas tcase, rebuilt front and rear axles from my 97' f350 parts...

Has anyone here messed around with rear steer? Not when something is broken, like swapping a Quadrasteer gm rear or building your own. What would be the upside to doing so, how difficult would it be to create, and would it be worth the extra time and money? I'm not considering this idea...

So I have a project I need help with. Im rewiring my AC controls to two on/off/on switches. I only have 2 air strength settings that work, and I only use hot and cold, and im fine with that. I made a 6 gang toggle switch panel and im using the first two toggles as my ac/ heat controls. My...

Im not on a complete junk yard budget, but id like to save money where I can

In san diego I dont know if the people know what they have

Whichever axle I go with, im fully building it before I throw it in. I know there's c clip eliminators, I think im going to go with the super 35, or a tj 44. I found a tj 44 and an 8.8 both for 200 out of wrecked vehicles, or ill just build mine. When I started this jeep project I never would've...

Can I use a c clip eliminator with this? I'm just not a fan of c clips

Im going for a more utilitarian build, so as long as it can hold up I dont favor one choice over the other. Super 35 could also allow me to keep the ground clearance so it definitely sounds better than a 8.8 or a 60

Does the super 35 eliminate c clips?

Nice rig, and thanks for the input. Definitely more experience on this forum than other places I've looked

I'll do that then, if I absolutely need to I can always get a different axle in the future. Really opening my mind to possibilities

Doesnt the JK Rubicon 44 come with air lockers?

I could stick to the dana 35, I just hear so much negative about it that I'd rather get a dana 44 at the very least. Im my experience the 35 is cheaply made, what's your view on the TJ 44? Any axle i put in will be trussed, and possibly sleeved if need be

I was dead set on dana 60s, but then I took axle clearance into effect. So now I'm debating between a built 8.8 or a built JK dana 44, or even a built TJ 44. Can someone with experience with these axles give input? I have a lot more experience with Toyota axles and dana 60s. Im locked in on an...

I just did a second lookover, the frame rot is only just starting near the wheel wells, I could patch it but id rather just get another frame. Was thinking new, but now I'm on the west coast everything here has significantly less rust, so I could go with a used frame