Recent content by robert_tj_ski

Yeah safety tcaps are more expensive... gonna go see a guy today and will see what he's gonna charge me

Looking for recommendations of where to buy a safety caps. Need to replace a section of a frame in the rear around the control arms. I'm located in new englad..... gotta love salt -_- Thanks guys you are always helpful Edit. And how much do you guys paid to replace them on both sides.

That's too far for me. I'm in Worcester area.

Yes I'm against the POR15 unfortunately. How did you prepped? You have to degrease everything. I feel like prep is the key... also did you just left it like that or top coat it with paint ? I've read you need to top coat it within so many hours for best results. I dont know what to do with...

I'm still working on it -_- . It's my second car too so I'm taking my time prepping it. It had POR15 applied by PO and originally I was going to reapply POR15 too but after what i discovered what's happening underneath that i dicided NOT to apply again. I talked to few ppl (including honest guy...

Wall, I've been cleaning the frame for past few days now... it all looked good till I got to rear end... hole about 1"wide... afraid it will get much bigger if I'll keep scraping it.... desicions desicions..... ugh

Ugh... The weather been acting up lately so I only got a chance to work on it for three day 2-3 hour after work... the more I'm under the jeep the more I'm thinking of bringing it to the shop to have it professionally undercoat. Going to stop by at the shop tomorrow to see what they gonna say...

How big of a air compressor did you use ?

You gonna need more then one, I stoped by today i got few more while they still have them. Yeah thing works great. I'm worry about those tight spots. Thinking of getting cheap sand blaster for these spots. Just I only have 5galon air compressor..

Yeah I might wait till the end and see..

Found one at harbor freight just its gravity gun, wondering if it would work for tub and such places that will need to turn the gun upward...

Thinking of buying a sandblasting gun for corners and tight spots and just some jelly for anything that is left

PO told me he had to weld a piece of metal on both sides because either the bolts snapped or he cut them off dont remember. ..

It's in working progress... need to still work on some tight areas... but I'm not even close to be done. Want to take my time cleaning it.

Started working on the frame. Ohhh it's not going to be a quick and easy project -_-