rraulston's latest activity

  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    So next weekend, I am going to put it up on my car lift and in 4wd and run it. Ill do a video. Yolk runout is what I will be looking...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    Well.............................................................................. The new front drive shaft did not fix the problem...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    You are raining on my parade!!! The new one will be installed on Friday and I will let you know!!
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    something is way off. You need to do this but rotate the assembly by hand. Its hard to tell how much of the run out is actual vs. needle...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    You had your rear rebalanced like my front. What are the chances you need a new rear driveshaft?? Just sayin!!
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    When I was checking the rear on mine, I jacked it up and ran the jeep up to 80. Vibrated a bit. Then I let it idle at about 25 MPH and...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    WOW....so here we go.... I remember when I was 17 and couldn't get my VW Baja Bug to run. New points and condenser on and on.... 3...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    ok, ill do that today, also, is there a reason I cant remove the front axels and drive it? The front wheel bearings are isolated right...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    2005 TJ Rubicon, 3" lift, 285/70-17 tires Starting with the front: straightened front Rubi 44 diff, new seals new axel u-joints. front...
  • rraulston
    rraulston replied to the thread Vibration at higher speeds.
    When you say mark the end to return it to phase, what does that mean?? I just bought a new Tom Woods driveshaft and there are no...
  • rraulston
    rraulston replied to the thread Oscillating Vibration.
    I'm going through the same thing.....what an expensive pain.....I did find that my front 44 diff was bent so that was a good catch, but...
  • rraulston
    Is there a PDF or some type of rebuild guide for a 241J?? I have the parts on order and was going to do a new video of a rebuild but...