Recent content by Scott89s

So I had some rust in around the hole for the upper control arm bolt on the frame just in front of the rear tire so I figured I'd cut out the rust and the weld so 1/8 plate over the hole. I know this is not technically the correct way, safety caps are, but my mounts aren't rusted out. it was...

Thank you Sent from my SM-G935V using Tapatalk

Little update. Sent from my SM-G935V using Tapatalk

So I've heard. It seems to be a good improvement I can maintain 70 pretty easily on the highways with the crazy wind off of the fields here in MI. I just find it odd that it's only in 4th and it's hit or miss if it happens. I think the idle issue is just the comp remapping itself then again I'm...

Well the stock injectors didn't look so good so I figure for 50 bucks for 4 flowmatched injectors why not the throttle body was free and I read more good reviews then bad and I'm my opinion it was an improvement. My cap and rotor was shot points were corroded wires were corroded. Sent from my...

And I did switch all my sensors from my 2.5 over to the 4.0 iac and housing, TPS and MAP Sent from my SM-G935V using Tapatalk

alright so I installed a 4.0 throttle body and spacer new plugs wires cap rotor and the 19lb 4 port injectors. I had the negative battery terminal disconnected for the whole time so I'm assuming the comp reset. Hers my problem at about 2k rpm in 4th gear it like sputters/hesitates and jerks for...

Thanks guys. I actually plan on 4.88s I'm not sure why I put 4.56s. I was back and forth at that time but after lots of research 4.88 is definitely the way to go. Sent from my SM-G935V using Tapatalk

Thank you Sent from my SM-G935V using Tapatalk

The day I bought her 1 week of owning her Sent from my SM-G935V using Tapatalk

Will do. Thanks for the help I'm sure I'll have more questions along the way Sent from my SM-G935V using Tapatalk

I know I asked earlier and nothing was really said but any opinions on BDS lifts? A local guy has a 2" lift with Springs and shocks for 300 new in box I think I could get him to 200ish. I know the warranty is great. Sent from my SM-G935V using Tapatalk

Well it'll be my DD with Trail driving 2-3 times a month I don't need a huge lift or the best but I do want a good solid components I know fox and OME are both very reputable problem is none of the components have the same amount of lift listed Sent from my SM-G935V using Tapatalk

Thank you I do like the look of your jeep I'm not sure I'd get as much lift since I have aftermarket bumpers and full doors quite a bit more weight. Also what height lift should I start thinking about the adj track bar? Sent from my SM-G935V using Tapatalk

Would building my own kit be a bad idea? I found OME 2.5" Springs and Fox shocks I can get for around 700 and that'll make it road worthy with good parts and just over time add more. I already have an adjustable track bar from rock krawler, just need the rear bracket. In the long run it may be a...