starkey480
Tuned springs club 28 From San Tan Valley, AZ
Latest activity Postings Attachments Images About
-
-
The replacement seal from @mrblaine arrived! Thank you sir! -
starkey480 reacted to rasband's post in the thread Fox 2.0 Front Shocks and Tower Relocation with
Like.
@starkey480 did an extension recently on his stem mounts - that might be the best approach I have seen (basically adding ~1" to the... -
starkey480 replied to the thread 2005 Rubicon; A Rubi Brother.When I did my write up on it, I was curious if anyone else will do it. Takes the right circumstances to have access to a set of old...
-
I kept the tj shock towers if you want to do the Starkey shock tower mod
-
starkey480 replied to the thread 2005 Rubicon; A Rubi Brother.At 2-3” of lift the short arm geometry isn’t too far gone. I’d put that money towards some good shocks once you have the lift height...
-
starkey480 replied to the thread 2005 Rubicon; A Rubi Brother.I’m not sure you’d see much benefit from the midarm on 33s. The geometry was set up for 4” lift and then you also need 1.25” body lift...
-
The Easter Bunny added a bung for the temperature sensor, so today I swapped the pan and filter (including the o-ring). I still need to...
-
It’ll take me awhile to get used to the look. Scrub radius improved, NW TireWorks did a fantastic job. Explained details about the wheel...
-
starkey480 replied to the thread Arizona Rock Crawling Daily Driver.I heard grease works well too. I’d try that next time but now both Jeeps in the family are auto!
-
I remember packing it with wheel bearing grease and then hammer a piece of a broomstick in to pop that bearing out . But that was more...
-
starkey480 replied to the thread Punk'n Stein: a TJLU 5.3 Vortec, stretched, 3/4-link custom mid-arm, highlined TJ.I really like both the Grenade and Machete wheels
-
starkey480 reacted to kmas0n's post in the thread Punk'n Stein: a TJLU 5.3 Vortec, stretched, 3/4-link custom mid-arm, highlined TJ with Like.
So, its become obvious, that I'm going to need wheels with more backspacing. I've always intended on bead locks anyways so i ordered up...
-
starkey480 replied to the thread Measure Once, Cut Twice: A Story of Excitement and Impatience.Looks great!
-
starkey480 reacted to taylormade73's post in the thread Measure Once, Cut Twice: A Story of Excitement and Impatience with Like.
Rough cut driver’s side. Will clean up with flap disk and file.
-
starkey480 replied to the thread Measure Once, Cut Twice: A Story of Excitement and Impatience.That sounds less messy than WD. Will have to try!
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…