Recent content by steed8950

Hi Jerry, I just purchased a hardtop, and took the rear retainer clips off that came with my soft top, because they look like they would interfere with the glass window closing fully. I wanted to be sure, are there clips that I can buy that screw into the same location that help the glass...

I'd like to replace the leather steering wheel on my 06 as well, I saw the same YouTube video from the Australian, the replacement steering wheels though I'm finding on ebay are not leather. I'm assuming just a vinyl plastic or something of the sort. Anyone have any thoughts on how they...

I replaced the cam position sensor from an aftermarket, NAPA one to the OEM one, and the wiring harness. That seems to have helped, unless its less than freezing. Then I'll still have issue again, previously it was happening at around 45 degrees. Sooo slight improvement.

I've used SVE Performance in New Haven, small shop but only works on Jeeps.

The frame is fine, I had some rust on some brackets that hold the side steps and in a few places under the hood, but I treated that with cleaner and POR 15

I was worried about quality of the aftermarket fenders, the price I was quoted for the two were about 900.00 and the rest for paint and prep. But I found these for about 300 https://www.discountbodyparts.com/details/Replacement/Fender/SET-J220101Q.html

I have a similar problem on my TJ, the front fenders have bubbling in the same location on both sides. I've spoken to several shops for estimates, they all say the fenders were previously patched and recommended replacing both. The tough part is i'm being quoted about 2 grand for...

Having the same issue on my 06. Dealer re-flashed the PCM, another shop replaced cam and crank position sensors and found the timing off. The CEL still comes on every morning. Bringing it back in shop this week, he seems to think that the timing may be slipping either due to a timing...

Thanks Matt, The link didn't come through. Would you mind sending it agin. What was the result after fixing the OPDA ?

I have a 2006 with the 4.0 manual. I had the same issue start in December with the same codes. P03344 and P0340, brought it to a shop who replaces the crank and cam position sensor and reset the timing. Issue seemed to be resolved for a short while, mainly due to warmer temps I think...