Recent content by Stefano

Got it. thx!

Are the bolts torqued to 55 ft lbs? Are the torque specs 55 ft lbs for those two bolts? With the extensions I’m having a hard time getting the click on the wrench, because the extensions are twisting due to the length. I wonder if I can go in from the top where the shifter is since I may use a...

Thank you! Great reference. Is the M12 the 2 star fasteners toward the top of the bell housing?

Thank you!!!!! Would you happen to know/ direct me where I can find the torque specs for all the bolts going around the bell housing to engine? I got the bottom ones but I’m not sure I’ve got the top ones especially the E12 nut fastener?

Does anyone know where you can purchase the cloth cover that sits above the trans gear box but below the stick shift? Better yet if you have a name for it that would be great! Thanks

Group, due to the age of my TJ I am concerned that some parts will be most difficult to find at the local auto stores. I hear the heater core is one that cant be purchased from a store as an example. I recent replaced a computer module and went through a member of the forum to get. Otherwise I...

Just following up on the post. Problem was the PCM module. Thank you for your help!

Thank you.

Would anyone happen to have a quick reference on where I could buy a harness for my 06 rubicon 6 speed manual?

Connector looked good. Wires and female pins fully extended. I even cleaned the pins on the connector with contact cleaner. Thanks Jerry

The issue I’m having with a bad PCM now all started by me replacing my car battery. Ever since then my gages started to act funny and the car would stall. Now I ordered a new PCM to fix my issue but I am worried the next time I have to disconnect my battery that I’ll burn another PCM. Is there...

hey guys, 06 TJ Rubicon manual transmission 143000 miles. Had an issue where the jeep just completely stops while I’m driving. It starts up OK and after around 15 minutes the RPMs and fuel tank gauges go to zero and empty respectively. Initially I had a P0201 error and a crankshaft position...

Manual

Any recommendations or link to the crankshaft sensor? Thanks

No jump start needed