Recent content by Tnraits

Appreciate it. For sure is a long journey, I’ve done a lot of work to this thing and it seems to be never ending. The jeep has been sitting longer than I would have liked, so I’m trying to revive this again because I miss driving it.

Thank you! It actually doesn’t look too bad down in the corner. Seems to be majority surface rust. My dad and I thought about welding in a plate on top as well. My only worry is if the plate is on top of the wheel well covering the whole, will the roll cage line up.

Appreciate it. Any recommendations on where to get patch panels for the interior corner? I’ve found parts for the floor and exterior corner but not yet for the inside.

Hi guys, Looking for insight here on my 02… what started as replacing the rear hinges turned into this chaos of a project. The rear passenger side corner where the roll cage meets the tub wheel well and floor behind the front passenger has some rust. The spot that was cut out had a sizeable...