TurboTJ's latest activity

  • TurboTJ
    I have a TJ Rubicon (so no SYE or transfer case drop needed) and a two inch lift. I had no vibes with this. Then I installed the Barnes...
  • TurboTJ
    TurboTJ replied to the thread Flat towing a TJ after re-gear.
    For your front diff there is no difference between driving and flat towing. Either way the wheels are turning the diff rather than the...
  • TurboTJ
    TurboTJ replied to the thread Smittybilt tow bar.
    I have flat towed for about 40k miles so far with no problems. My setup is very similar to Mr. Bills although my lights are wired in.
    • IMG_0046.jpeg
  • TurboTJ
    What is that spinning shaft I see about halfway through the video?
  • TurboTJ
    TurboTJ replied to the thread Front & Rear Manual Locking Hubs.
    I flat tow my TJ behind my truck camper and it has almost no effect on gas mileage. Well, maybe half a mile per gallon, at 10 mpg towing...
  • TurboTJ
    I had vibes after rebuilding my front drive shaft. I took it out and had it rebalanced at a drive shaft shop. It reduced the vibes but...
  • TurboTJ
    TurboTJ reacted to Painfultruth's post in the thread Turbo with Like Like.
    A properly setup turbo with appropriate gearing will completely transform your sled. It should be a requirement not a recommendation.
  • TurboTJ
    TurboTJ replied to the thread Rubicon Locker: Fact or Myth.
    The Rubicon rear diff is a gear type limited slip. It does not have clutches that engage or disengage per se.
  • TurboTJ
    TurboTJ replied to the thread Front wheel drive binding.
    I recently had my rear drive shaft out because of a failing U-joint and drove the jeep for a couple hundred of miles in 4HI, front wheel...
  • TurboTJ
    TurboTJ replied to the thread Strange vibration.
    I put the new drive shaft from Tom Woods in today. Man, is that shaft smooth! Not a hint of vibration…. or noise.
  • TurboTJ
    TurboTJ replied to the thread Magnum supercharger.
    I have been running the Banks turbo system now for about 7 years. It has been rock solid and I have had no difficulty with it...
  • TurboTJ
    TurboTJ replied to the thread Lockers don't engage.
    The rear locker wasn’t locking because I didn’t S-turn enough. The front locker wasn’t locking because of a broken ground wire to the...