Recent content by verf

Thanks, I’ll get in there tomorrow. Picked up the hardware locally. I’ve never used nutserts, can you suggest a quality one? I appreciate your time and knowledge!

I might just have a shop do it…but I’ll dig around the internet and see if anyone has a better way. Thanks for the insight!

Thank you!

So about 11 years ago I purchased their rock sliders for my LJR. Life and a few moves later, I’m ready to install them. However, I lost the box with the instructions and most importantly, the hardware. I know Zach passed away years ago, great guy. Looks like the business isn’t open anymore...

Found light scoring on the passenger side. I don’t have an indicator, but I couldn’t feel any ridges with finger tip/fingernail. Will it be ok if I replace the seal? It’s a Dana 44. You guys have been a great help to me and it’s really appreciated!

Hubs are out, other side was much easier. Should I remove the axles and if so, what should I inspect? Anything special before putting the axle shaft back in? Thanks again! It’s much appreciated!

‘06 Rubi Unlimited… Removed the spindle hardware and the 3 hub bolts, but neither hub budged. Tried brake cleaner, PB Blast, hammer and then opted to open up the slide hammer… Without thinking, I grabbed the front hub puller, but instead of the slide, I used the center bolt to push on the axle...

I actually just finished putting my netting back on. The plug just sits there. I didn’t cut it out in case something could short (I’m no electronics guru) I replaced everything but the speaker wires. Why? Because the wires coming out of the Pioneer head unit are a 20/22 and stick wiring...

For the over 6/6'1" folks, did raising the seat make seeing traffic lights more difficult? I'd like to see more front end, but at stock seat height on a. 4.25" lift, I either have to stop well short of the light or lean/crane forward and look up to see it. And can you still use the tops...

Great thread all! Recently liner the interior of tub and lost some seat hardware, figured I'd just look into a kit. I'm 6'2" with a 34' inseam. I've owned sports cars my whole life, so sitting low in the seat didn't feel off to me. But I'd like a little more over hood visibility. My question...

Do you own seat risers? Some say if your over 6 foot to get the 1 inch, others say 1.5 or 2 inch for tall people. Thanks

Thanks all. Shame no one sells bolt kits in here. my other vehicles are easy to find things. But trying to find the exact size, thread pitch, info itself for each original bolt so I can order the right sizes. We have a Lowes, so gonna try them. No Ace or HD around here. Thanks for the info!

Took the Heep apart months ago, bagged and tagged it all. Still can't find some stuff and need to replace others. Hoping someone has a link. Snapped a front seat bolt installing it, so going to replace them all. I've tried Rock Auto, as that place usually has the odd bolt or whatnot. Thanks!

I'm at a loss on the sub/amp plug. New speakers, sub (in OEM spot), mono amp for sub and Pioneer head unit. Is the plug (wired to radio, not sub side) now useless? For the rear speakers, am I required to rewire directly from pod speakers to new head unit? Some articles mention it, but...

In the middle of putting new system in. What happens with the original giant sub plug/wires? Just tape it up and leave it? Or is there something I've got to cut and splice. I'm no electronics guru, lol. TIA