Transfer case torque shaft bracket

Garjowan

Member
Joined
Sep 10, 2021
Messages
41
Location
Ashby, MA
In removing my torque shaft bracket to mount a drop bracket, I had to cut the little bolts off.
Not realizing there were threaded spacers in the rubber bushings…
These seem to be unavailable…

Do you think just using some 1/4-20 bolt will work to mount it back on the tunnel?
Do you think those sleeves are integral to the shifter operations????

Thanks for any input!
 
Well the 1/4-20’s worked perfectly…
I also used some small 3/8” long sleeves to put in the rubber grommets as well, to take up the torque of the handle movement.
Worked awesome.

So if anyone had to go my route, it works great.

4 1/4-20 bolts 1.25 long
6 fender washers
4 1/4-20 lock nuts
And 4 1/4 X 3/8 metal sleeves
 
  • Like
Reactions: TJ Jim