Steering question

NWPA Jeepy T

NWPA Jeepy T

TJ Enthusiast
Supporting Member
Joined
Nov 5, 2019
Messages
701
Location
NW PA
I'm trying out my new steering disconnect to prevent theft

Seriously, PO made the tie rod and drag link - 1 ton steering. Ends, he said, are 90s GM with 7/8 thread. Having trouble finding them. 6 3/8 from end to grease fitting, 7 1/2 overall, 3 1/2 from thread to grease fitting. Calipers said .86" or 21.9mm for threaded end. Anyone have an idea on part for this? Drag link to pitman in this application
Thanks

20230204_170052.jpg
 
Man I went through a similar ordeal once- if you will get on the moog website it will give you the specs on every drag link/ tie rod end they sell- its a big chart and has the thread, left hand/Right hand , length and taper (I think) -

It took a little work but I was able to find the one I needed.
 
  • Like
Reactions: NWPA Jeepy T
cpwolf said:
Oof, rather than chase this, I would do the Moog ZJ conversion for lower cost, or a Currectlync if $ aren’t an issue.
Click to expand...

I had the ZJ on my last TJ and it was great. I'm not sure why he built 1 ton steering for a 4.0 on 35s - seems overkill. I'll still look at Moog like AndyG suggested first and go from there
 
Top Bottom
Back