How thick is the area where the shackle tabs are welded on?
It’s made out of 3/16” plate, with exception to the shackle mounts. Not sure how thick those are off the top of my head.
Last edited:
How thick is the area where the shackle tabs are welded on?
I’m all for the frame lift mod, but it’s out of mine and most folks skill set.
I’m also all for a new small business creating TJ products. I like it
Yep. Why even drive a Jeep if you aren't gonna chop the back of the frame off and weld it back on an inch higher?
I modified a high clearance bumper to make it into what I wanted it to be by adding a lower lip to wrap the cross member and adding width to protect the tub corners. I might have the skill set for a frame raise, but I haven't had a garage setup with enough space to do that and honestly I'm not even sure I'm mentally prepared to do it.
If this bumper had existed (or if it did, and I had known about it) in March of 2022 I'd probably have bought this one and never though about it again. Instead I have the body lift butt crack reminding me on the daily that I haven't done a frame raise.
Let’s do the frame tuck together. I’m planning mine at the end of June. I’m ready mentally (know what I have to do), just waiting on a part for another project I’m doing at the same time.
- Upper perch relocation
- Gas tank cut off correction
- Rear frame tuck
- 10mm spacer for passenger side to level the rig.
Let’s do the frame tuck together. I’m planning mine at the end of June. I’m ready mentally (know what I have to do), just waiting on a part for another project I’m doing at the same time.
- Upper perch relocation
- Gas tank cut off correction
- Rear frame tuck
- 10mm spacer for passenger side to level the rig.