Search results

  1. sycboi

    Rockauto customer service

    Sounds like he ordered a standard TJ 8-piece set and they forgot the rocker panel pieces in that kit… They still made a mistake though, unfortunately…
  2. sycboi

    Rockauto customer service

    My experience was that the unlimited set had to be ordered in a six piece kit and then the rocker panels purchased additionally… I did not realize they were offering an eight piece for the unlimiteds…
  3. sycboi

    Rockauto customer service

    That’s what I was alluding to. I see them available separately, but not included in the Unlimited 6-piece kit/set…
  4. sycboi

    Rockauto customer service

    Which part number did you order? The carpet kit for the TJ Unlimited I’ve seen doesn’t include the rocker carpet…
  5. sycboi

    Looking for correct 05-06 NSG370 gearshift bezel

    Mr. Blaine is exactly correct. Your TJ should have the top style , ‘05-‘06… You have the older style shown at the bottom of the picture…
  6. sycboi

    Eaton ELockers (pre-purchase inspection photos)

    Many times when the Eaton E-lockers arrive those tabs you see spot welded to them are broken off. He’s just be proactive with the seller. Rightfully so…
  7. sycboi

    Will a grille from a 97 TJ fit on a 06 TJ?

    It’s a ‘97 thing for sure. I changed my ‘97 grille and hood out for the newer versions…
  8. sycboi

    WTB: Driver’s side lower door hinge…

    I need a driver’s side lower door hinge… Located in Norwalk, Ohio 44857… -Michael
  9. sycboi

    What is everyone using to treat / corrosion proof their aluminum skids with?

    I had my UCF transfer case skid plate and Savvy gas tank skid plate both clear hard anodized. It’s not the answer for everyone but I like it a lot for how I use my Jeep… I wil say I’ve had good luck on aluminum with Red Scotch-Brite, U-POL Acid #8 Etching Primer and then paint of choice. I...
  10. sycboi

    Half doors and hard top

    Yes. No issues at all…
  11. sycboi

    How can I fix this Dana 35 axle seal leak?

    You can, but I wouldn’t bother with just rectifying one side. If one side is that bad chances are the other side is not far behind…
  12. sycboi

    How can I fix this Dana 35 axle seal leak?

    You need new axle shafts, bearings and seals. The picture you posted shows where the bearing has eaten into the axle shaft. The axle can’t run true through the seal and will always leak… Circled is where the shaft is compromised. Arrow shows the metal remnant dust from the destruction as you...
  13. sycboi

    Johnny Joint Maintenance

    If only grease came out just wipe it off and call it a day. If a poly race was extruded out from the pressure that will be obvious after wiping any excess grease away…
  14. sycboi

    Fun pulling a Hemi

    Been there myself. Mine came out of a Red Dodge Ram as well. We took the “easy” way out and pulled the cab off of the frame first…
  15. sycboi

    Johnny Joint Maintenance

    It is nearly impossible to get the JJ zerks to accept grease most, if not all, of the time... Then there are the rare instances where it does accept grease and then you pump enough in to blow it apart…
  16. sycboi

    What are these things behind the grill in each corner?

    The first one is most likely your ambient air temperature sensor for the AC. The other one is probably a wiring connector for a temp sensor for the optional temp display rear view mirror…
  17. sycboi

    Inner fender felt fit

    Take the one you have and use it as a template to make two new ones… I used high traffic mat bulk material from Menard’s… Or go this route…55174658AD
  18. sycboi

    Duroflex vs Johnny Joints...again

    As far as the hex versus round arms. It’s really a non-issue… I bought all 8 Savvy double-adjustable control arms. I installed them and adjusted my front and rear pinion angles by hand... No tools needed as long as everything is prepped properly. I took off each JJ and added a more uniform...