Search results

  1. RHanna

    Piss & Moan Table

    I don't have any personal feelings towards runners or bikers but I can't stand to see them on the road I live on. They are crazy to even be on that road. The lanes are normal width but not as wide as some main roads and if they need to get off the road for an emergency, most of the time they...
  2. RHanna

    Piss & Moan Table

    On the face near your eyes really sucks. You can't go crazy spraying medicine. I've never had it down below but I'm sure that really sucks. The place I remember the most is in between all of my fingers. That drove me crazy because the bumps would constantly rub slightly making them itch all...
  3. RHanna

    Brake pad part

    After doing a little bit of research it looks like the pads are from 2003 explorer and the caliper piston on a 2003 explorer looks similar to what I have on my jeep. The problem is I think the rotors match exactly for the 1996 explorer and the pads and calipers are from 2003 explorer. Not...
  4. RHanna

    Brake pad part

    Changing the pads and rotors on my rockjock dana 60 I contacted Currie before ordering. They told me to order for a 1996 explorer and that's what I used to order from rockauto. The rotors seem to fit correctly and the pads look correct but this 3 prong on the back of the pad that goes into the...
  5. RHanna

    WiFi Signal Strength

    What service with AT&T do you have? We went with att fiber about a year ago. Before we had comcast and the router was on the far end of my house. My wifi was spotty in the backyard/porch area. I had att run the cable into the laundry room because it's in the middle of the house, downstairs...
  6. RHanna

    Radiator replacement

    They look like self tapping but they aren’t doing a very good job of tapping. I just don’t understand why they would supply self tapping when it’s their radiator. They should know the thread.
  7. RHanna

    Radiator replacement

    I'm struggling with the stupid fan shroud bolts that came with the radiator (I assume they are for the shroud since I just reused the radiator mounting bolts. You would think that they would fit the fan shroud holes but they don't. They start going in like they fit because the bolts are...
  8. RHanna

    How to flush the cooling system on your Jeep Wrangler TJ

    Thanks, I would be a little surprised jut because my heater works great and the coolant that is leaking out of my current radiator doesn't look that bad. Of course I don't have experience flushing the system so I'll keep that in mind.
  9. RHanna

    How to flush the cooling system on your Jeep Wrangler TJ

    I'm about to flush my system to prepare for a new radiator. Quick question, if I pull the thermostat and put the housing back on does the coolant/distilled water go through all of my coolant system hoses/engine block/heater core?
  10. RHanna

    What did you do to your TJ today?

    Rented a coolant pressure tester from advanced auto and it took all of about 10 seconds to realize my radiator is done. I'm a little surprised I have any coolant left with how fast it was draining out of the holes/cracks. I could hear it dripping in the pan I placed underneath at 7 psi Bought...
  11. RHanna

    Decent tool set for the teenager (not Jeep specific)

    No input on brand but check out some pawn stores first.
  12. RHanna

    What did you do to your TJ today?

    Not something that I did to the jeep but a tool I snagged on ebay came in the mail today. The johnny joint tool for 2.5" for $66. Now if I can just modify it a little to use on the 2" ends.
  13. RHanna

    Ticking time bomb?

    300+, you'll have to add axle shafts and brakes
  14. RHanna

    TJ Unlimited Rubicon Front Driveshaft U-Joint

    I can take my front driveshaft out without dropping the skid but it is tight. The first time you might want to drop the skid just in case the bolts are tight.
  15. RHanna

    Woman forced to sell her dream car after paying $40k in interest over 3 years

    Maybe they should have made the title of the article. "Dumbass rolls negative equity from last car into new car loan with a double digit interest rate during the lowest interest rate environment in our country's history"
  16. RHanna

    Woman forced to sell her dream car after paying $40k in interest over 3 years

    Maybe she should ask Biden to forgive this loan
  17. RHanna

    What do I have? Help me spend money

    It looks like part of you skid is welded to the frame and it attaches your arms. How will you do a full replacement without replacing the arms? You could get more belly clearance if you went with a full replacement. UCF isn’t “amazon” fast with their shipping but probably better than savvy.
  18. RHanna

    What do I have? Help me spend money

    The UCF engine skid attaches to the bottom of the motor mount and that's the worst part of the install in my opinion. I think that would mean it covers more up front than your current skid. The distance from the front of the skid to the back is roughly 32" and that's the 2002 version. You...
  19. RHanna

    TJ Rear Antirock Install Interference Suggestions

    How close are yall to the brake caliper? If I move the link perfectly straight up and down like the instructions say I'm extremely close. Does it really have to be perfectly straight up and down? The instructions say to level the 3 hole on the tab before welding, is that really necessary? Why...
  20. RHanna

    What did you do to your TJ today?

    I’m going to hire someone to weld the rear Antirock sway bar pieces to my axle but I want to prep it before contacting someone. There isn’t much room and the brake line is in the way right now. Should I just move the line to the front of the axle? Can I just bend those lines or will they kink?