Search results

wondering first off where the TCM for the trans is located? Is it part of the PCM or in a different location? And any help on diag of this is appreciated Thanks

Posted this earlier but fluid was low added fluid. Jeep runs. Trans shifts no issues. Code seem to clear then come back. Is this the beginning of something catastrophic? Fluid level in trans is good. Any info appreciated.

I’ve got a lot going on here it all started with a leaky radiator, then I found the water pump I changed a year ago is now leaking then this two fault codes came up. P0743 means torque converter trans is low on fluid. Then to top it off my code reader will not power up when connected to the...

So I bought a new starter and installed it on a 2001 jeep wrangler automatic. It’s a little noisy is there a difference between starters for automatics and starters for a manual transmission?

Update: replaced motor and resistor. At the moment and it’s working (all positions) so ****FYI old blower would still function with full 12 volts directly from battery but hook up to circuit, no good*****. I did add the relay as suggested from another poster and was able to get it to work. Only...

Never mind I found it

Never mind I found it

plus there are so many adds on here they make it even more difficult to navigate when searching for something … very frustrating while searching for info while in the middle of troubleshooting…🙄

Does anyone know where the blower motor relay is located? Please!

There is nothing grounded on mine according to the diagram that isn’t what’s on mine look at my pics.

Is this the blend door actuator? Hey thanks for the above diagram that helps tremendously

When you say left footwell is that the drivers side footwell like by the pedals?

Amazon

I went ahead and ordered a new blower fan and resistor. ***** But one thing I need to know is where all the grounds are landed and I need to check to see if they are grounded properly or wire broken etc…****any help with this would be appreciated

So from the relay there is a smaller yellow wire and a white wire. Wich one Igor’s to positive power and which one goes to ground?

I ordered a relay and connector on Amazon

So I kept playing around with the wiring got blower fan to work but the air would only blow through defrost then when I went to mount everything blower quit working again wtf! 🤬

I was out of town trying to get back into this now . I saw on here some where someone posted a relay into the blower motor speed circuit I can’t find link would someone repost for me please

Question where is the the “blower motor relay” located

Looks like a slight bit of melting goin on here