Search results

  1. Fughuert

    Fuel gauge not working, PCM issue?

    Fuel gauge isn't working, I replaced the pump with a bosch since I had one incase the original was bad while I dropped the tank, but the original and the bosch both tested good with an ohm test. I got the same reading on the connection to the PCM as the pump sending unit, C3 pin 33 "fuel level...
  2. Fughuert

    Rear upper links mounted behind the axle

    https://bringatrailer.com/listing/2014-jeep-wrangler-34/
  3. Fughuert

    Increasing steering angle

    Would there be anything wrong with replacing the steering stop bolts and replacing with ones without a welded stop nut to increase the steering angle? I can reweld the new stop nut if it's advised. I'm finding plenty on adding washers to stop rubbing but I'm not having that issue. I have...
  4. Fughuert

    Diagnosing noise from 2.5 (could it be the timing chain?)

    I noticed this noise start up at first it was a light metallic rattle only heard at idle but now it sounds like someone shaking a jar of rocks, still only really heard at idle and shows no other issues. Seems to increase with engine rpm but I can't hear it running down the road, only while...
  5. Fughuert

    Should the yoke retaining nut on SYE be hard to thread by hand?

    Stupid question, but I bought a sye over the deal weekend and while I won’t be installing it til next spring I checked it out to make sure all is there and the yoke retaining nut will thread on maybe two three turns by hand then I can’t turn it anymore. I understand they’re one time use, is this...
  6. Fughuert

    Replacement axle side front trackbar bracket, bolt hole slightly bigger than trackbar accepts

    Bracket: https://www.barnes4wd.com/Jeep-TJ-LJ-MJ-XJ-and-ZJ-Front-Axle-Track-Bar-Bracket_p_818.html Replaced my wallowed out front axle trackbar bracket on my Dana 30 as I presume it was the cause of my wobble @ ~45mph with a barnes 4wd bracket, got it all welded up only to find the bolt that fits...
  7. Fughuert

    No temp gauge and no start. Let it sit and then temp gauge works and TJ starts fine

    Went out for a 15 minute errand round trip didn't pay attention to the temp gauge but when I pulled into the driveway I noticed the temp needle was pegged at the lowest it will sit. It showed no signs of actually overheating as well. Shut down engine and I tried cycling the key to see if the...
  8. Fughuert

    Two unique shock outboards

    Found on craigslist.